Sanyo VCC-HD5400P Service Manual page 16

Privacy mask
Privacy Mode
Up
Left Right
Down
8. Gyro Offset Adjustment
Adjustment location: EIS Adj of computer screen
Measuring location: Computer screen,
Measuring equipment:
Note: Do not shake the camera while gyro offset is being
Tele
Adjustment method:
1. Connect the camera's USB terminal to the computer'
Wide
USB connector.
2. It turns on power.
3. Double-click on the DscCalDi.exe.
4. Select "EIS Adj" on the LCD "Test".
OK
5. Gyro offset adjustment value will appear on the screen.
6. Click the OK.
Adjustment value determination is effectuated using the
"Offset" values. If
Offset= H1,V1
The adjustment values fulfill the conditions below, they are
determined as within specifications.
Adjustment value determination
409<=H1<=614, 409<=V1<=614
9. Privacy Masking Adjustment
Adjustment location: Computer screen
Measuring location: Computer screen, Monitor screen
Measuring equipment: Computer screen,
Adjustment method:
1. Set the camera unit lens 3.5 m from the privacy masking
chart.
2. Connect the power board unit and the computer using a
network cross-wire cable.
3. It turns on power.
4. Run IE on the computer, and connect to http://
192.168.0.2/cgi-bin/mechachousei.cgi.
5. Click ADJ "START" in the IE window.
- -
16
adjusted. There is no gyro gain adjustment.
3.5 m
Camera
Privacy masking chart
(Mechanism)
Privasy
masking
chart