Fault Code F16 Excess Foam - Miele W1113 Technical Information

Technical Information
3.9 Fault Code F16, Excess Foam
Symptom
During operation the Oversudsing LED lights up. The Water Intake
Solenoid Valve is switched off for certain periods of time. The
heating is switched off and the thermostop is skipped. The spin
speed is reduced (or stopped). An additional rinse cycle is
performed.
Cause
Excess foam due to too much detergent and/or improper detergent
Remedy
Ensure the correct type and amount of detergent is being used.
Cause
Not draining.
Remedy
Check the Drain Pump system for proper operation .
3.10 Fault Code F20, Heating
Symptom
During operation, this fault is not indicated via any LEDs on the
Control Panel. The program continues, however poor wash results,
and longer than usual operating times may be noticed.
Cause
The water is not being heated.
Remedy
Check the Heater Relay and Relay circuit.
Check the Heater Circuit for an open or short circuit.
W1113, W1119, W1203, W1213 & W1215 Clothes Washers
52