070-1 Drum Lamp Assembly; Fault Code F63 Water Path Control Unit - Miele W1113 Technical Information

W1113, W1119, W1203, W1213 & W1215 Clothes Washers
3.16 Fault Code F63, Water Path Control Unit
Symptom
The Water Intake LED flashes. On units with a display, 3 dashes
are displayed. The water intake valves are closed and the program
is interrupted. The Drain Pump is activated for 120 seconds.
Cause
Faulty Water Path Control System.
The Control/Power Module cannot register a valid position from the
the Water Path Control Unit within about 80 seconds of it being
switched on.
Note
Water intake monitoring is not active if a valid position of the Water
Path Control Unit is not registered.
Remedy
Check the Water Path Control Unit
Check the Water Path Control System circuit.
3.17 Fault Code F65, Drum Light Assembly Fault
Symptom
On units with a display 3 dashes are displayed; the program is
interrupted and the Drain Pump is activated for 120 seconds.
Cause
Drum Light Assembly - not installed / not installed correctly
Remedy
Check Drum Light Assembly is installed.
Check the Drum Light Assembly is in the locked position (turned
completely and seated).
Check the base of the Drum Light Assembly; ensure the
actuator tab is present (refer to Figure 070-1).
Figure 070-1: Drum Lamp Assembly
55
Technical Information