Nokia 2650 Service Manual page 14

nokia
C P
ONNECTING EOPLE
CMO Operations & Logistics
CMO OL WW Service Solutions & Development
Bochum / Germany
16.) Placement of the Coax Cable in the Upper Block.
18.) Open the Coax Connector of the Engine Module
carefully by using tweezers.
20.) Remove the Coax Cable carefully.
always starts with the Coax Connector Antenna,
"stretch" the cable towards hinge area carefully, then
the same procedure when assembling at Engine Module
side.
22.) Put the Lower Block on the Upper Block as shown in
the Picture.
Service Manual 2650/2651 Level 1&2
PAGE 14 (24)
CONFIDENTIAL
17.) Placement of the Coax Cable in the IHF Antenna
Module.
19.) Note the exactly position when laying the Coax
Cable during assembly.
When assembling 21.) Unscrew the two Torx Plus
Lower Block.
torque of 6Ncm has to be used.
23.) Lift the shown side of the Flex Connector carefully
by using the Flex Opening Tool as a lever.
For assembly, a Torx Plus
Copyright © 2004-2005 Nokia Corporation. All rights reserved.
Approved 3.0
MGR
10.2.2005
size 5 screws from
®
driver with a
®