Maintenance Overview - Toshiba Magnia 550D User Manual

Connecting Components

Maintenance overview

WARNING: Never disassemble the server more than described in this manual.
Failure to observe this precaution could result in electric shock, cause a system
fault, or void your warranty.
When performing maintenance on the server, follow these general steps.
1 Turn off all peripherals connected to the server.
2 Turn off the server.
3 Unplug all power cables from their AC outlets. Disconnect all cables connected to
the back of the server.
4 To access the inside of the server, remove the front and side panels. For
instructions, see
5 Perform any required maintenance.
CAUTION: Make sure that components handled during system maintenance are
properly installed and connections are securely seated. Also check that no tools or
hardware items are left inside the server.
HINT: The procedures for removing and installing hard disk drives depend on the
drive type—IDE or SCSI. Be sure to check the drive's specifications before
attempting to install or remove a drive.
6 Reinstall the front and side panels.
page 33.
7 Reconnect all signal and power cables.
8 Turn on the server and run any required system checks.
Some optional devices require you to reconfigure the server's software, and/or
change jumper, and/or DIP switch settings before the device can be used.
In addition to the instructions in this chapter, refer to the manufacturer's user manuals for
the devices you are installing/removing.
Removing and replacing the server panels
Removing and replacing the server panels
Installing optional devices
on page 33.
on
31