Display Functions Selection - Benelli 2009 TREK1130 Workshop Manual

GEN
INFO

DISPLAY FUNCTIONS SELECTION

N N OTE:
The amendment or adjustment operations of the
display functions must be carried out after three
seconds from engine start-up, without subsequently
activating the clutch lever
The display is provided with 3 primary functions:
a
"Total"/ "Trip"
b
"Chrono"/ "Lap"
c
"Clock"/ "Trip"
a
To switch from "Total"/"Trip" to
press the START button for more than two seconds.
b
To switch from "Chrono"/"Lap" to
press the START button for more than two seconds (with
chronometer at a stand still).
a
"Clock"/"Trip" to
To switch from
press the START button for more than two seconds.
Partial odometer resetting
The value of the "Trip" function is reset by pressing the
START key twice consecutively (with engine running and
without pulling the clutch).
N OTE: N
The equipment has an integral memory preserving
all parameters even with the engine off. With the
exception of the reset clock and of the "Trip" function,
all other parameters remain in the memory even in
case of disconnection from the battery.
Set "Chrono"/"Lap"
Switch to b display.
To start the "Chrono" press the START button for less
than one second.
To view "Lap" from the "Chrono" position, press the
START button for less than one second.
Every time the START key is pressed for less than one
second, the "Lap" function will display the time on the
"Chrono" at that moment (lap time).
To stop the "Chrono" press the START button for less
than one second.
To reset the "Chrono" press the START button for at
least three seconds.
To exit from the "Chrono" position press the START
button for at least two seconds moving to the
"Clock"/"Trip" display.
Set "Clock"/"Trip"
c
Switch to display.
To adjust the clock, press the START button for at least
two seconds.
The first hour digit starts to flash.
Repeatedly press the START button to adjust the digit
until the wanted digit is reached.
1 4
b
"Chrono"/ "Lap",
c
"Clock"/"Trip",
c
"Total"/"Trip",
c
Press the START button for at least two seconds and
adjust the next digit.
Repeat the procedure to adjust the second hour
digit, the first and second minutes digit.
Press the START button for at least three seconds to
interrupt the selection and the flashing.
To reset the "Trip" from the display
the START button twice consecutively.
Set "Km"/"Mi"
a
From the display "Total"/"Trip" with engine
running, keep the START button pressed for at
least ten seconds.
The "Km" or "Mi" symbol will start to flash, press the
START button to switch to "Km" or "Mi".
Press the START button for at least two seconds to
select the wanted unit of measure, automatically
switching to the °C or °F selection.
Press the START button for less than one second to
select the wanted unit of temperature.
Press the START button for at least three seconds to
confirm and exit from the Set "Km"/"Mi" display.
Set "Service"
Upon reaching the first 1.000 Km (621 Mi) and every
10.000 Km (6.213 Mi), the flashing "Service" warning
light will be displayed instead of the partial "Trip" for
10 seconds upon every vehicle ignition.
To reset the "Service" warning light, keep the START
button pressed for at least ten seconds until the
warning light switches off.
FEATURES
a
"TOTAL"/ "TRIP"
(Start>2sec)
b "CHRONO"/ "LAP"
(Start>2sec with
chronometer
at a stand still)
c
"CLOCK"/ "TRIP"
(Start>2sec)
a
c
press