Adding Equipment To Your Airbag-Equipped Vehicle - Isuzu 2008 i290 Owner's Manual

Adding Equipment to Your
Airbag-Equipped Vehicle
Q:
Is there anything I might add to or change
about the vehicle that could keep the airbags
from working properly?
A:
Yes. If you add things that change your vehicle's
frame, bumper system, height, front end or side
sheet metal, they may keep the airbag system from
working properly. Changing or moving any parts
of the front seats, safety belts, the airbag sensing
and diagnostic module, steering wheel, instrument
panel, roof-rail airbag modules, ceiling headliner
or pillar garnish trim, front sensors, or airbag wiring
can affect the operation of the airbag system.
In addition, your vehicle has a passenger
sensing system for the right front passenger's
position, which includes sensors that are part
of the passenger's seat. The passenger sensing
system may not operate properly if the original
seat trim is replaced with non-Isuzu covers,
upholstery or trim, or with Isuzu covers, upholstery
or trim designed for a different vehicle. Any
object, such as an aftermarket seat heater or
a comfort enhancing pad or device, installed
1-74
under or on top of the seat fabric, could also
interfere with the operation of the passenger
sensing system. This could either prevent proper
deployment of the passenger airbag(s) or prevent
the passenger sensing system from properly
turning off the passenger airbag(s). See Passenger
Sensing System on page 1-68.
If you have any questions about this, you should
contact Customer Assistance before you modify
your vehicle. The phone numbers and addresses
for Customer Assistance are in Step Two of
the Customer Satisfaction Procedure in this manual.
See Customer Satisfaction Procedure on page 7-2.
Q:
Because I have a disability, I have to get
my vehicle modified. How can I find out whether
this will affect my airbag system?
A:
If you have questions, call Customer Assistance.
The phone numbers and addresses for Customer
Assistance are in Step Two of the Customer
Satisfaction Procedure in this manual. See
Customer Satisfaction Procedure on page 7-2.
In addition, your dealer/retailer and the service manual
have information about the location of the airbag sensors,
sensing and diagnostic module and airbag wiring.
2008 - Isuzu 290/370 Owner Manual