Manual Transmission Fluid; When To Check; How To Check - Isuzu 2008 i290 Owner's Manual

How to Add Automatic Transmission
Fluid
Refer to the Maintenance Schedule to determine what
kind of transmission fluid to use. See Recommended
Fluids and Lubricants on page 6-12.
Add fluid only after checking the transmission fluid while
it is hot. A cold check is used only as a reference. If
the fluid level is low, add only enough of the proper fluid
to bring the level up to the HOT area for a hot check.
It does not take much fluid, generally less than one pint
(0.5 L). Do not overfill.
Notice: Use of the incorrect automatic transmission
fluid may damage your vehicle, and the damages
may not be covered by your warranty. Always
use the automatic transmission fluid listed in
Recommended Fluids and Lubricants on page 6-12.
•
After adding fluid, recheck the fluid level as
described under "How to Check Automatic
Transmission Fluid," earlier in this section.
•
When the correct fluid level is obtained, push the
dipstick back in all the way; then flip the handle
down to lock the dipstick in place.
2008 - Isuzu 290/370 Owner Manual

Manual Transmission Fluid

When to Check

A good time to have it checked is when the engine oil is
changed. However, the fluid in your manual transmission
does not require changing.

How to Check

Because this operation can be a little difficult, you may
choose to have this done at your Isuzu dealership
service department.
If you do it yourself, be sure to follow all the instructions
here, or you could get a false reading.
Notice: Too much or too little fluid can damage
your transmission. Too little fluid could cause
the transmission to overheat. Be sure to get an
accurate reading if you check your transmission
fluid.
Check the fluid level only when your engine is off, the
vehicle is parked on a level place and the transmission
is cool enough for you to rest your fingers on the
transmission case.
5-19