Setting Preset Stations - Isuzu 2008 i290 Owner's Manual

qr © ¨
or SEEK: Press the SEEK arrows or
depending on the radio, the TYPE arrows to go to the
previous or to the next station and stay there.
The radio only seeks stations with a strong signal that
are in the selected band.
qr © ¨
or SCAN: Press and hold either SCAN
arrow or either TYPE arrow for two seconds until SCAN
or SCN displays and a beep sounds. The radio goes
to a station, plays for a few seconds, then goes to
the next station. Press either SCAN arrow or either
TYPE arrow again to stop scanning.
To scan preset stations, press and hold either SCAN
arrow or either TYPE arrow for more than four seconds.
PSCN or PSC displays and a double beep sounds.
The radio goes to a preset station, plays for a
few seconds, then goes to the next preset station.
Press either SCAN arrow or either TYPE arrow again to
stop scanning presets.
The radio only scans stations with a strong signal that
are in the selected band.
2008 - Isuzu 290/370 Owner Manual

Setting Preset Stations

Up to 18 stations (six FM1, six FM2, and six AM), can
be programmed on the six numbered pushbuttons,
by performing the following steps:
1. Turn the radio on.
2. Press AM-FM on the AM-FM Radio or BAND to
select FM1, FM2, or AM.
3. Tune in the desired station.
4. Press and hold one of the six numbered
pushbuttons until a beep sounds. When that
numbered pushbutton is pressed, the station that
was set, returns for that pushbutton.
5. Repeat the steps for each pushbutton.
The Radio with Six-Disc CD player is capable of storing
an equalization setting to a preset station. Do the
following steps for selecting an equalization setting:
1. Tune to the preset station.
2. Press and release the AUTO EQ button to select
the equalization setting.
Once the equalization no longer displays, the
equalization is set for that preset station.
3-49