Isuzu 2008 i290 Owner's Manual page 174

©
5. Press either the left
© ¨
the left or right SEEK arrow to exit program
type select mode.
SCAN: Scan the stations within a PTY by performing
the following:
1. Press the TYPE button to activate program type
select mode. P-TYPE and the last selected PTY
displays.
2. Turn the TYPE knob or press and release the
TYPE button to select a PTY.
3. Once the desired PTY is displayed, press and hold
©
either the left or right
© ¨
or right SEEK arrow for two seconds, and
the radio begins scanning the stations in the PTY.
©
4. Press either the left
© ¨
the left or right SEEK arrow to stop scanning.
BAND (Alternate Frequency): Alternate frequency lets
the radio switch to a stronger station with the same
program type. To turn alternate frequency on, press and
hold BAND for two seconds. AF ON displays. The
radio can switch to stations with a stronger frequency.
To turn alternate frequency off, press and hold
BAND again for two seconds. AF OFF displays.
The radio does not switch to other stations.
3-52
¨
or right TYPE arrow or
¨
TYPE arrow or the left
¨
or right TYPE arrow or
Setting Preset PTYs (RDS Only) (Radio
with Six-Disc CD)
These pushbuttons have factory PTY presets. Up to
12 PTYs (six FM1 and six FM2), can be programmed on
the six numbered pushbuttons, by performing the
following steps:
1. Press BAND to select FM1 or FM2.
2. Press the TYPE button to activate program type
select mode. P-TYPE and the last selected PTY
displays.
3. Turn the TYPE knob or press and release the
TYPE button to select a PTY.
4. Press and hold one of the six numbered
pushbuttons until a beep sounds. When that
numbered pushbutton is pressed, the PTY that was
set returns.
5. Repeat the steps for each pushbutton.
2008 - Isuzu 290/370 Owner Manual