Replacing Light Bulbs - Toyota tundra 2003 User Manual

Replacing light bulbs—

The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
D To prevent burning yourself, do not
replace the light bulbs while they
are hot.
D Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
300
'03 TUNDRA_U (L/O 0307)
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just
windshield fogged up in the rain. However,
if there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light,
Toyota dealer.
if
Light bulbs
Headlights
Front fog lights
Parking/front
like the
turn signal/front
side marker
lights
Rear turn signal
contact your
lights
Stop/tail/rear
side marker
lights
Back−up lights
License plate
lights
High mounted
stoplight and
cargo lamps
Interior light
Personal lights
Vanity light
2003 TUNDRA from Jul. '03 Prod. (OM34430U)
Bulb
W Type
No.
— 60/55 A
9006 51 B
3157NA 27/8 C
3157A 27 D
3157 27/8 D
921 18 D
168 5 D
921 18 D
— 8 E
— 8 E
— 1.5 E