Factory Image; Physical Configuration; Commonality Between Dl380 G5 Storage Server Configurations - HP ProLiant DL380 G5 Administration Manual

Table 10 Commonality between DL380 G5 storage server configurations
Feature
Server family
Chip set
Hard drives
Drive controller
Expansion slots (5 total)
Hot plug cage
Hot plug back panel
Power supply
Optical drive
Fans
Video
NIC (embedded)
Server connections
Server management

Factory image

The ProLiant DL380 G5 Storage Servers are preconfigured at the factory for the operating system only.
Additional configuration is needed for the creation of data drives. Depending on the type of storage
server, storage configuration can involve local storage configuration using the HP Array Configuration
Utility, Adaptec Storage Manager, or SAN management tools.
Physical configuration
Each ProLiant DL380 G5 Storage Serverr comes with two hot-pluggable and hot-swappable HDDs
loaded with the operating system only. The drives are configured by default into two RAID 1 logical
disks at the controller level as shown in
38
Storage server specifications and image configurations
Item
ProLiant DL380 G5
Intel 5000P
Two HP 36–GB, 3 Gb, 10 K, SAS small form factor
HP Smart Array P400 with 512 MB Battery-Backed Write Cache (BBWC)
Two PCI-X 64–bit 133 MHz
Two PCI-Express x4 low-profile, half height (one used for Smart Array P400
controller
One PCI-Express x8 full-height, full length
Eight small form factor SAS/SATA
Yes
Two (redundant and hot swappable)
DVD+R/RW (8x)
Twelve (fully redundant and hot swappable)
ATI RN50 with 32 MB of video memory
Two NC373i multifunction gigabit
Five USB ports (2 front, 2 back, 1 inside)
One PS2 keyboard
One PS2 mouse
One serial port
Two VGA (1 front, 1 back)
One iLO 2 with dedicated network port
Figure 15.