Cutting The Data Of A Selected Region (Cut); Erasing The Data Of A Selected Region (Erase) - Tascam HS-4000 Owner's Manual

7 – Timeline mode

Cutting the data of a selected region (Cut)

When you cut a selected region, the data that follows it shifts
forward.
NOTE
• The cut data is stored in the copy buffer.
• If an entire fade (in/out) is included in the selected region,
the settings of that fade will also be copied.
• If the IN point or OUT point is in a region, any parts outside
the designated cut region become new regions.
• If the IN point or OUT point is in a fade in or fade out, that
fade in/fade out is cleared.
1. Press the HOME key on the front panel to open the Home
Screen.
2. Touch the EDIT MODE button to enter edit mode.
If "TIMELINE Rec Tracks" is set to "2trx2", select the tracks to
be cut.
3. Move the timeline cursor to the region that you want to cut.
4. If you want to set editing start and end points, touch the IN/
OUT button to open a pull-up menu and use its SET IN and
SET OUT buttons to select the regions you want to cut.
5. Touch the EDIT button to open a pull-up menu.
6. Touch the Cut button in the pull-up menu to cut the
selected region. When the operation completes, the Home
Screen will be shown again after a pop-up message appears.
At this time, the EDIT pull-up menu will still be open.
60
TASCAM HS-4000

Erasing the data of a selected region (Erase)

When you erase a selected region, that region becomes silent.
The data that follows it does not shift.
NOTE
• The erased data is stored in the copy buffer.
• If an entire fade (in/out) is included in the selected region,
the settings of that fade will also be copied.
• If the IN point or OUT point is in a region, any parts outside
the designated region become new regions.
• If the IN point or OUT point is in a fade in or fade out, that
fade in/fade out is cleared.
1. Press the HOME key on the front panel to open the Home
Screen.
2. Touch the EDIT MODE button to enter edit mode.
If "TIMELINE Rec Tracks" is set to "2trx2", select the tracks to
be erased.
3. Move the timeline cursor to the region that you want to
erase.
4. If you want to set editing start and end points, touch the IN/
OUT button to open a pull-up menu and use its SET IN and
SET OUT buttons to select the regions you want to erase.
5. Touch the EDIT button to open a pull-up menu.
6. Touch the Erase button in the pull-up menu to erase the
selected region. When the operation completes, the Home
Screen will be shown again after a pop-up message appears.
At this time, the EDIT pull-up menu will still be open.