Lock Function - Tascam HS-4000 Owner's Manual

3 − Preparation

Lock function

Press the MENU key while pressing and holding the HOME
key on the front panel to open the LOCK SETUP screen. On
this screen, you can turn the lock function on or off. The lock
function prevents operation from the front panel and external
devices.
The front panel is divided into two sections, which can be locked
and unlocked separately. In addition, operations from external
devices are divided into four categories that can each be locked
separately.
The REMOTE section lock settings are divided into settings for
use with on-air mode and for use with all other modes.
In addition, when in on-air mode and the ON AIR button is on,
you can use the OnAir-ON SAFE section button to set whether or
not to lock all transport functions except those in the following
table. This applies regardless of the type of device used for
operation, including front panel and remote control keys and
the function keys of an external keyboard.
Transport operations not locked by OnAir-ON SAFE
STOP
PLAY
PAUSE
ONLINE
FLASH START
If you press the button for a section, it changes from UNLOCK to
LOCK (with a yellow background) and the locked area appears
dimmed.
Everything locked
• When the LCD Section is set to LOCK, the following pop-up
message will appear if you touch the display.
28
TASCAM HS-4000
Display (panel) locked
• The following pop-up message will appear if you use any of
the controls around the display.
Display (controls) locked
• When the Transport section is set to LOCK, the following
pop-up message will appear if you use any of the transport
keys.
Transport locked
• When in on-air mode, the ON AIR button is ON and the
OnAir-ON SAFE section is set to LOCK, the following pop-up
message will appear if you try to use any transport controls
(including keys on the front panel and remote control and
the function keys of an external keyboard) other than those
in the "Transport operations not locked by OnAir-ON SAFE"
table to the left.
• If the REMOTE section current operation mode is set to
LOCK, the following pop-up message will appear if you try
to use the control connected to the remote connector.
Remote locked