Automatically Cutting Unnecessary Silences When Recording (Silent Cut Function); Automatically Adding Marks At The Position Where Recording Restarts - Tascam projector Owner's Manual

Automatically cutting unnecessary
silences when recording (silent cut
function)
When recording, the unit can pause when it detects silence
for a certain amount of time, and then restart recording
when it detects an input signal again. Since this cuts
unnecessary silence during recording, space on the card
can be conserved.
1. Set the item on the Function Screen and
A . REC
the item on the
LEVEL
described above.
2. Use the DATA wheel to select the
and press the ENTER/MARK button.
3. Use the DATA wheel to set it to
4. Press the MARK (Â) button to return to selecting
items.
5. Use the DATA wheel to select the
and press the MARK (¯) button.
6. Use the DATA wheel to set the silence that must be
detected before recording is paused between 1–5
seconds (default value: 1 seconds).
7. When you have finished making the settings, press the
HOME/DISP button to return to the Home Screen.
8. Press the PAUSE button to start recording standby.
When the input sound exceeds the level set in the
item, recording starts automatically.
LEVEL
When the input sound level is below the level set in
the item for a set number of seconds, recording
LEVEL
automatically pauses.
When the input sound exceeds the level set in the
item again, recording restarts automatically.
LEVEL
menu page as
AUTO REC
item,
S I LENT CUT
(default value:
ON OFF
S I LENT DELAY
Automatically adding marks at the
position where recording restarts
You can set whether a mark is added or a new take is
created whenever input higher than the set auto rec level
is detected after the input level has been below the auto
rec level for one second or more.
1. Set the
A . REC
the item on the
LEVEL
described above.
2. Use the DATA wheel to select the
press the ENTER/MARK button.
3. Use the DATA wheel to set it to
).
(default): Auto mark function off
OFF
: After the input level has been below the set
MARK
auto rec level for one second or more, when input
higher than the auto rec level is detected again, a mark
is added at that position. Recording continues in the
item,
same take.
: After the input level has been below the set auto
TAKE
rec level for one second or more, when input higher
than the auto rec level is detected again, recording
continues in a new take. After pausing because of
activation of the silent cut function, recording restarts
in a new take.
4. When you have finished making the settings, press the
HOME/DISP button to return to the Home Screen.
5. Press the PAUSE button to start recording standby.
Depending on the setting, a mark is added or a new
take is created when recording starts automatically.
4 – Recording
item on the Function Screen and
menu page as
AUTO REC
AUTO MARK
or
MARK TAKE
TASCAM DR-680
item, and
.
33