Installing The Bottom Trim; Replacing The Oven Door - GE JTP85 Series Installation Instructions Manual

INSTALLING THE BOTTOM TRIM

Make sure the flat
15
side is up on the
bottom trim.
Find the Key Slot
16
on the back of the
trim.
Lower trim mounting rivet
on bottom of side trim
18
Push the trim down
until it snaps into
place.
CAUTION: Be sure you do not tip the
oven foward during installation or you
may bend the Bottom Trim. The Bottom
Trim provides an opening for cooling air
to enter the cabinet. This opening should never be
blocked.
Key hole slot and wide
flange at top
Match the key slot with
17
the rivet on the bottom
of the side trim
Push trim down at both
ends until it snaps into
place.

REPLACING THE OVEN DOOR

Make sure the hinge is in the door stop position.
19
Remove the toweling or
20
paper towel holder from
the hinge.
Grasp the door on both
21
sides.
Hold the door over the
22
hinges aligning the
hinges with the hinge
slots on the bottom of the
door.
23 Slide the door down onto
the hinges as far as it will
go.
24 Close the door.
The oven door is heavy. You may need help lifting
the door high enough to slide it down onto the
hinges. Do not lift the door by the handle.
7