Step 4, Install Bottom Trim; Step 5, Install Bottom Trim With Accessory Drawer; Step 6, Install Mounting Screws; Step 7, Finalize Installation - GE CSB9120 Installation Instructions Manual

4 INSTALL BOTTOM TRIM
If installing the Advantium
CAUTION
120V Oven below 36 , you
must use the plastic bottom trim due to burn risk
to children. The plastic trim acts as insulation
and will help prevent burns to children from hot
surfaces.
NOTE: If installing the Advantium 120V Oven
with an accessory storage drawer, the bottom
trim is not required. Proceed to Step 5.
• Installation Below 36 , align trim tabs on the
plastic trim to slots in the bottom of the oven.
• Installation Above 36 , align trim tabs on the
plastic or metal trim to slots in the bottom of the
oven.
• Secure the bottom trim to the bottom of the
oven using 3 screws provided.
5 INSTALL BOTTOM TRIM WITH
ACCESSORY DRAWER
If installing with an accessory drawer, see
installation instructions that come with the
accessory drawer.
Installation Instructions
Plastic
Trim
Plastic
Trim OR
Metal
Trim
6 INSTALL MOUNTING SCREWS
• Slide the oven the remaining way into the
opening so that the side flanges and control
panel are against the cabinet frame. Make sure
that the oven is centered in the opening.
• Open the door, place a turntable tray in the oven
and make sure that the tray in the unit is level.
• Drill pilot holes through the side flanges.
• Drive the color-matched screws into the side
flanges. It is recommended that the screws
be hand tightened.
If installing oven with an accessory storage
drawer:
• Open the drawer.
• Drill pilot holes through the side flanges.
• Drive color-matched screws into the side flanges.
It is recommended that the screws be hand
tightened.
NOTE: If installing the Profile Advantium 120V
Oven with an accessory storage drawer, you
must use the Under-the-Counter (UTC) mounting
bracket for the drawer.
If installing the Monogram Advantium integrated
model ZSC1201 above 36 , the UTC mounting
bracket for the accessory storage drawer must be
used.
7 FINALIZE INSTALLATION
• Turn power on at the source. The interior light
should come on when the door is opened.
• Refer to Owner's Manual for operating
instructions.
14