GE JKP90 Installation Instructions Manual
  1. Manuals
  2. Brands
  3. GE Manuals
  4. Oven
  5. JKP90
  6. Installation instructions manual
GE JKP90 Installation Instructions Manual

GE JKP90 Installation Instructions Manual

27" and 30" built-in wall oven with microwave
Hide thumbs Also See for JKP90:
Table of Contents

Advertisement

Quick Links

See also: Owner's Manual , Instruction and Installation Manual
Ilnstallat!on
nstruct=ons
Built-In Wall Oven
with Microwave
27" (68.6 cm) model
JKP90
30" (76.2 cm) models
JTP90, PT970
If you have questions, call 1.800.GE.CARES
or visit our website at:
ge.com
Before You Begin
Read these instructions carefully and completely.
• IMPORTANT-save
these
instructions
for local inspector's
use.
• IMPORTANT-observe all
governing
codes and ordinances.
• Note to Installer--Be
sure to leave these
instructions
with the consumer.
• Note to Consumer--Keep
these
instructions
for future
reference.
• Proper installation
is the responsibility
of the installer
and product
failure
due
to improper
installation
is NOT covered
under warranty.
• NOTE--This
appliance
must be properly
grounded.
• ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired)
into an approved junction
box. A plug and receptacle
is NOT permitted
on these products.
Parts Included
(Appearance
will vary.)
Screws For
Installation
(8-18 x .750
fiat head Phillips
wood screws)
31-10648-1
Optional 27"
(68.6 cm) Metal
Bottom Trim
Assembly (on
some models or
can be purchased
separately)
03-07
JR
27" (68.6 cm)
Metal Bottom Trim
30" (76.2 cm)
Metal Bottom
Trim Assembly
Materials Needed
Strain Relief Clamp
Junction
for 1/2" conduit
Box
Wire Nuts
36" (91 cm)
of String
Tools Needed
1/8" Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JKP90 and is the answer not in the manual?

Questions and answers

Related Manuals for GE JKP90

Summary of Contents for GE JKP90

  • Page 1 Microwave Ilnstallat!on 27" (68.6 cm) model nstruct=ons JKP90 30" (76.2 cm) models JTP90, PT970 If you have questions, call 1.800.GE.CARES or visit our website at: ge.com Before You Begin • Proper installation is the responsibility of the installer and product...
  • Page 2 Installation Instructions IMPORTANT SAFETY INSTRUCTIONS Electrical For Your Safety Requirements (cont.) • Be sure your oven is installed properly a qualified installer or service technician. Rating plate is located on the inside watt of the • Be sure the oven is securely installed in a microwave oven.

  • Page 3: Pre-Lnstallation Checklist

    Installation Instructions Pre-lnstallation Checklist Door removal is not a requirement Remove packaging materials. Check installation of the product, but is an inside microwave, behind hinges and under false bottom. Remove labels on added convenience. To remove the door: the outside of the door, plastic on trims Open the oven door as far as it will go.
  • Page 4 Installation Instructions IA1 Cutout for 27" (68.6 Built-In Oven with Microwave models only For JKP90 model only. 5" (12.7 cm) Max. f romthe Cabinet Width 27" (68.6 cm) left or right Cabinet Junction Box Recommended Width Location Cutout Location from Floor 21 5/8"...

  • Page 5: Built-In Oven

    Installation Instructions Cutout for 30" Built-In Oven (76.2 cm) with Microwave models only For JTP90, PT970 models only. Cabinet Cabinet Width 30" (76.2 cm) Width 20" (50.8 cm) 30" (76.2 cm) Recommended Cutout Location Cutout Width from Floor Junction Box 21 5/8"...
  • Page 6 Installation Instructions Cutout for Built-In Oven with - Over Microwave models only a Warming Drawer For JKP90, JTP90, PT970 models only. 27" (68.6 cm) Oven with 30" (76.2 cm) Oven with Microwave Oven (Model Microwave Oven (Models JTP90 and PT970) Over a...

  • Page 7: Electrical Connections

    Installation Instructions Electrical Connections Turn off the circuit breaker or remove ATTENTION INSTALLER fuses to the oven branch circuit. All electric wall ovens must be hard wired With the oven supported on a table or (direct wired) into an approved junction platform in front of the cabinet opening, box.
  • Page 8 Installation Instructions IBIElectrical Connections cont. New Construction Three-Conductor Branch Four-Conductor Branch Circuit Connection Circuit Connection When connecting to a three-conductor branch circuit, if local codes permit: • When installing in new construction, a. Connect the bare oven ground conductor • When installing in a mobile home, or with the crimped neutral (white) lead to •...
  • Page 9 Installation Instructions lcl Securing the Oven in the Opening Sliding the Oven Into the Drilling the Pilot Holes and Opening Mounting the Oven a. Loop (do not tie) a 36" (91 cm) string around the conduit before the oven is slid NOTE: Before drilling the pilot holes, into place.
  • Page 10 Installation Instructions Preparing for the Bottom Installing the Metal Trim Installation Bottom Trim Place the bottom metal trim centered over a. With oven installed, take the bottom trim and center it on the bottom front edge of the pre-drilled mounting holes.

  • Page 11: Replacing The Oven Door

    Installation Instructions Replacing the Oven Door Open the oven door as far as it NOTE: The oven door is heavy. You will open. may need help lifting the door high enough to slide it into the hinge slots. Push the hinge locks up against the Do not lift the door by the handle.

  • Page 12: Pre-Test Checklist

    Installation Instructions Pre-Test Checklist Remove all protective film, if present, heck that the bottom trim is installed properly (see page 10). and any stickers. Check to be sure that all wiring is heck to be sure the mounting screws are installed and flush with the side trim secure and not pinched or in contact with moving parts.

This manual is also suitable for:

Jtp90, pt970

Table of Contents