Page 1
Installation 30" Built-In Wall Oven with Microwave Instructions JTP86, JT965 If you have questions, call 1.800.GE.CARES or visit our website at: www.GEAppliances.com Before You Begin • Proper installation is the responsibility of the installer and product failure due Read these instructions carefully and completely.
Installation Instructions IMPORTANT SAFETY INSTRUCTIONS Electrical For Your Safety Requirements • Be sure your oven is installed properly a qualified installer or service technician. This appliance must be supplied with the • Be sure the oven is securely installed in a proper voltage and frequency, and connected cabinet that is firmly attached to the house...
Installation Instructions Pre-lnstallation Checklist Remove packaging materials. Check Door removal is not a requirement for installation of the product, but is an inside microwave, behind hinges and added convenience. To remove the door: under false bottom. Remove labels on the outside of the door, plastic on trims and panel, all tape around the oven, Open the oven door as far as it will go.
Page 4
Installation Instructions [_ Pre-lnstallation Checklist cont. Remove the bottom trim from the top lace the oven on a table or platform of the oven. It will be installed at the even with the cutout opening. (Platform must support 255 Ibs.) end of the installation process.
Page 5
Installation Instructions Cutout for Built-In Oven with Microwave Cabinet Cabinet Width 30" _Width 1-201-1 30" Recommended Minimum Cutout Location Cutout Width Junction Box , Location Allow 11/16" for from Floor 21 5/8" overlap of oven over side edges 23 112" Min. Cutout Depth o1 cutout _ Cutout Width...
Installation Instructions Electrical Connections Turn off the circuit breaker or remove ATTENTION INSTALLER fuses to the oven branch circuit. All electric wall ovens must be hard wired With the oven supported on a table or (direct wired) into an approved junction platform in front of the cabinet opening,...
Page 7
Installation Instructions IBI Electrical Connections cont New Construction and Three-Conductor Branch Four-Conductor Branch Circuit Connection Circuit Connection When connecting to a three-conductor branch circuit, if local codes permit: • When installing in new construction, a. Connect the bare oven ground conductor •...
Installation Instructions Securing the Oven in the Opening Sliding the Oven Into the Drilling the Pilot Holes and Opening Mounting the Oven a. Loop (do not tie) a 36" string around the conduit before the oven is slid into place. NOTE: Before drilling the pilot holes, This will keep the conduit from falling make sure the oven is pushed as far...
Page 9
Installation Instructions To install a single metal bottom trim assembly (on some models), use sections C3 and C4. To install a metal bottom trim with a plastic bottom trim (on some models), use sections C3-C5. Preparing for the Bottom Installing the Plastic Bottom Trim Installation Trim (on some models)
Page 10
Installation Instructions 151 Replacing the Oven Door _'-_ Open the oven door as far as it NOTE: The oven door is heavy. You will open. may need help lifting the door high enough to slide it into the hinge slots. _"_ Push the hinge locks up against the Do not lift the door by the handle.
Installation Instructions Pre-Test Checklist Remove all protective film, if present, heck that the bottom trim is installed and any stickers. properly (see page 9). Check to be sure that all wiring is heck to be sure the mounting screws are installed and flush with the side trim secure and not pinched or in contact with moving parts.