How To Force A Certain Port To 10Mbps Speed And Half-Duplex Mode - Compex SAS2224 Quick Install Manual

7. After the Half LED lighted up, the port LEDs will flash in sequence from port #1 to
port #24.
8. Press Set button once when the desired port is flashing. When selected, this port LED
will remain lighted for Half mode. For Full mode, the LED will turn OFF.
9. To save your configuration, press the Set button and hold it down for about 3 seconds
until all selected LEDs are flashing.
NOTE
To configure a port to auto-negotiation mode, turn OFF that port LED in both 100M
and Half mode setup.
9.7.

How to force a certain port to 10Mbps speed and Half-duplex mode

1. Press the Mode button several times until the Half LED lights up. Check the LED for
that port number you want to set.
2. If the port has already forced to Half-Duplex mode, this means that the Port LED has
lighted up, please proceed to Step 6. Otherwise, please continue with the procedure
listed below.
3. After the Half LED light up, the port LEDs will flash in sequence from port #1 to port
#24.
4. To select the desired port, press the Set button once when the desired port is flashing.
When selected, this port LED will remain lighted up for Half mode. For Full mode,
the LED will turn OFF.
5. After selecting the desired port, press the Set button and hold it down for about 3
seconds until all LEDs flashes. The port LED you have set will remain lighted up
indicating a successful configuration.
6. Next press the Mode button until the 100M LEDs lights up. Check the LED for that
port number you want to set.
14 24-port 10/100Mbps Fast Ethernet Switch
with Power Buttons
SAS2224
English