Description (Fig. 1) - DeWalt D25980 Instruction Manual

• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropriate
for the dust exposure. Direct particles away from face and body.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty. All users and bystanders MUST ALWAYS
wear certified safety equipment:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ...............volts
Hz .............hertz
min ...........minutes
........direct current
.............Class I Construction
.................(grounded)
.............Class II Construction
.................(double insulated)
.../min ......per minute
RPM .........revolutions per minute

DESCRIPTION (FIG. 1)

WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A ............amperes
W ...........watts
.........alternating current
.........alternating or
..............direct current
n o ..........no load speed
...........earthing terminal
..........safety alert symbol
BPM ......beats per minute
24
A. On/off switch
B. Side handle(s)
FIG. 1
B
A
C
D
OPTIONAL ACCESSORIES (FIG. 2)
Various types of 28 mm hex. chisels are available as an option.
E. Pointed chisel (DT6927)
F. Cold chisel (DT6929)
G. Scaling tool (DT6932)
H. Spade chisel (DT6928)
Consult your dealer for further information on the appropriate
accessories.
C. Tool retainer
D. Tool holder
B
I. Asphalt cutter (DT6934)
J. Driver ground rod (DT6933)
K. Shank tamper (DT6935)
L. Plate tamper (DT6936)