RACOM RE400 Quick Start

Hide thumbs Also See for RE400:

Download this manual See also: Operating Manual

1. The first start of radio modem

•

Don't connect radio modem in your LAN before settings! Default IP address of radio modem may

be already used in your network.

•

Do not switch on more than one radio with default settings at any one time! Only switch on the next

one after setting and storing IP parameters in the first one.

•

Interconnect ETH connector of radio modem with your PC using standard cable.

•

Switch on power (PoE or AUX). PWR and ETH LED have to light. After 20 sec. STATUS starts to

blink in green.

•

Set IP and mask of your PC to 192.168.1.233, mask 255.255.255.0 (check user manual).

•

Start www browser on address 192.168.1.2.

•

Set radio modem configuration and Save it.

•

Select a unique IP address of each radio modem within the network.

•

When IP address is changed, conection with radio modem is lost. Next communication is possible

after change of IP address in www browser, possibly in your PC.

Quick Start - RE400

6/1/2010

Page 1 Select a unique IP address of each radio modem within the network. • When IP address is changed, conection with radio modem is lost. Next communication is possible after change of IP address in www browser, possibly in your PC. © RACOM s.r.o. – Quick Start - RE400...
Page 2 4+5 minus to pins 7+8 the polarity can be inverted also Other options with PoE adapter see the standard IEEE802.3af. • ! Only ONE from above power possibilities can be used ! Quick Start - RE400 – © RACOM s.r.o.
Page 3 Green blinking with period 2 sec ON, 1 sec OFF – main mod • Yellow blinking with period 1 sec ON, 1 sec OFF – Service mode • Yellow blinking with period 0,2 sec ON, 0,2 sec OFF – Bootloader mode © RACOM s.r.o. – Quick Start - RE400...
Page 4 -25 až +55 °C Storage temperature range -35 až +85 °C Case dimensions 137 × 96 × 31 mm Weight 0.3 kg * Channel spacing 6.25 kHz is not approved under EU rules. Quick Start - RE400 – © RACOM s.r.o.