Storing Machine; Recommended Stock Items - Tennant 3000 Operator And Parts Manual

OPERATION
4. Remove foam filter and tap off dust after each
month of use. Filter is located below the
secondary filter. Replace filter when worn
(Figure 8).
FIG. 8
ATTENTION: Clogged filters or vacuum hose will
cause vacuum motor to overheat and shut down on
thermal overload.
5. Inspect vacuum hose for air leaks, replace if
damaged.
6. Inspect lid gasket for leakage, replace if worn.
7. Clean machine with an all purpose cleaner and
damp cloth as needed.
8. Every 250 hours of operation, check vacuum
motor carbon brushes for wear. Replace brushes
when worn to a length of 10mm (0.38 in) or less.
Contact Service Center for carbon brush
inspection.
FOR SAFETY: When servicing machine, all repairs
must be performed by a qualified service person.
14
Home Find... Go To..

STORING MACHINE

Prior to storing machine, wrap power cord around cord
hook, clean all filters and install a new vacuum bag.
Store machine in a dry area.
WARNING: Do Not Use Outdoors Or On Wet
Surfaces. Do Not Expose to Rain. Store Indoors.

RECOMMENDED STOCK ITEMS

Refer to Parts List section for recommended stock
items. Stock Items are clearly identified with a bullet
preceding the parts description. See example below:
Tennant 3000/3040/3050 (06- -03)