Do not handle plug with wet hands. – Keep cord away from heated surfaces. – Do not pick up burning or smoking debris, such as cigarettes, matches or hot ashes. – Report machine damage or faulty operation immediately. Tennant 3530/3560/3580 (11–99)
Secure with washer and nut (Figure 4). 3. Push excess cord slack up into cord grip. Tighten cord grip with 5/16 inch wrench until cord is secure. DO NOT overtighten. 4. Connect exhaust hose to bottom of handle housing. FIG. 4 Tennant 3530/3560/3580 (04–99)
FIG. 6 11. Connect 840mm (33 in) vacuum hose to squeegee assembly and to neck on machine lid (Figure 7). FIG. 9 2. Make sure automatic float shut-off screen is in place (Figure10) . FIG. 7 FIG. 10 Tennant 3530/3560/3580 (11–99)
OPERATING ACCESSORY TOOLS 3. Begin operating by pushing and pulling machine in 1. Connect 3 m (10 ft) vacuum hose to machine either direction. cover snout. 2. Select desired accessory tool and connect to vacuum hose (Figure 12). Tennant 3530/3560/3580 (04–99)
1. Push machine to nearest floor drain, if not available use a bucket to drain machine. 2. Remove drain hose from holder, twist off drain hose knob and drain. Raise hose to stop flow of water (Figure 15 ). Tennant 3530/3560/3580 (04–99)
4. Check bag for fullness, empty bag at 3/4 full. 5. Wipe machine housing with a nonabrasive, nonsolvent cleaner. 6. Check cords and cord grips for damage. If worn or damaged, replace immediately. Coil cord neatly. Tennant 3530/3560/3580 (04–99)
Debris is wedged under squeegee blade. Wipe off squeegee blades. Squeegee blades are worn. Replace squeegee blades. Squeegee blade is loose. Tighten thumbscrews. Vacuum hose connection on squeegee Push vacuum hose onto squeegee mount mount is loose. securely. Tennant 3530/3560/3580 (04–99)