Turn On The Computer; Set Up Windows - Panasonic CF-30 series Operating Instructions Manual

3
2
1
3
3

Turn on the computer.

A Pull the carrying handle forward.
B Push and hold the latch (A), and lift open the display.
C Slide and hold the power switch
power indicator lights.
CAUTION
Do not slide the power switch repeatedly.
The computer will forcibly be turned off if you slide and hold the power switch for
four seconds or longer.
Once you turn off the computer, wait for ten seconds or more before you turn on
the computer again.
Do not perform the following operation until the hard disk drive indicator
Connecting or disconnecting the AC adaptor
Sliding the power switch
Touching the keyboard, touch pad or touchscreen (only for model with touchscreen)
Closing the display
When the CPU temperature is high, the computer may not start up to prevent
overheating of the CPU. Wait until the computer cools down, and then turn the
power on again. If the computer does not power on even after cooling down,
contact Panasonic Technical Support.
4 Setup Windows.
A Follow the on-screen instructions.
CAUTION
When you set date/time/time zone and click [Next], the screen may not go to the
next step for a few minutes. Do not touch the keyboard or touch pad, and wait
until the screen changes.
If "An unexpected error has occurred..." (or a similar message) is displayed,
click [OK]. This is not a malfunction.
Wait until the hard disk drive indicator
This computer periodically records the management information including the
hard disk information such as number of hours powered-on, number of times
powered-on, internal temperature, replacement sector. The maximum data vol-
ume for each record is 750 byte. These information are only used for estimating
the cause when the hard disk goes down by any possibility. They are never sent
to outside via network nor used for any other purpose except for the purpose
described the above.
To disable the function, add the check mark for [Disable the automatic save
function for management information history] in [Hard Disk Status] of PC Infor-
mation Viewer, and click [OK].
<For MUI OS model>
The keyboard will operate as the US keyboard until the keyboard setting is
changed. Because of this, some alphabets shown on display may differ from
inputted ones.
To avoid the accidental selections, during setting up Windows,
Use the touch pad to make some selections.
Press the NumLock key and input in the Ten-key mode to input numbers.
To match the languages, change the language settings after setting up Win-
dows ( page 14). Do not change the settings in [To change system or these
settings, click Customize] of [Regional and Language Options] during setting up
Windows.
for approximately one second until the
has turned off.
turns off.
13