Turn On The Computer - Panasonic CF-C2 series Operating Instructions Manual

First-time Operation
18
4 Connect your computer to a power outlet.
The battery charging starts automatically.
CAUTION
 Do not disconnect the AC adaptor and do not switch the wireless switch to on
until the fi rst-time operation procedure is completed.
 When using the computer for the fi rst time, do not connect any peripheral device
(including wired LAN cable) except the battery pack and AC adaptor.
 Handling the AC adaptor
 Problems such as sudden voltage drops may arise during periods of thunder and
lightning. Since this could adversely affect your computer, an uninterruptible power
source (UPS) is highly recommended unless running from the battery pack alone.
5

Turn on the computer.

Slide and hold the power switch
( page 13) lights.
CAUTION
 Do not slide the power switch repeatedly or do not hold the power switch for four
seconds or longer.
6 <For MUI OS model>
Select language.
Select language and OS (32-bit or 64-bit).
CAUTION
 Carefully choose your language because you cannot change it later. If you set a
wrong language, you need to reinstall Windows.
A Select language on "Your display language" and click [Next].
Follow the on-screen instructions.
A Select language and OS (32bit or 64bit) on "Select OS" screen and click [OK].
The language setting will start by clicking [OK] on the confi rmation screen.
You can return to the "Select OS" screen by clicking [Cancel].
The language and OS setting will be completed in about 15 minutes.
B When termination screen is displayed, click [OK] to turn off the computer.
C Turn on the computer.
7 Setup Windows.
Follow the on-screen instructions.
 The computer restarts several times. Do not touch the keyboard or touch
pad, and wait until the drive indicator
 After the computer is turned on, the screen remains black or unchanged for
a while, but this is not a malfunction. Wait for a moment until the Windows
setup screen appears.
 During setup of Windows, use the touch pad and clicking to move the pointer
and to click an item.
 Setup of Windows will take approximately
20 minutes.
Go to the next step, confi rming each message on the display.
 Follow the steps below.
A When "Enable sensors" is displayed, click [Enable this sensor].
B When the [User Account Control] screen is displayed, click [Yes].
C At the [Display Rotation Tool] confi rmation screen, click [Yes].
The computer restarts automatically, and the setting is enabled.
"Join a wireless network" screen may not appear.

You can set the Wireless Network after the setup of Windows is complete.
( page 13) until the power indicator
has turned off.
5 minutes /