Audison LRX 6 SR Owner's Manual
  1. Manuals
  2. Brands
  3. Audison Manuals
  4. Car Amplifier
  5. LRX6SR
  6. Owner's manual
Audison LRX 6 SR Owner's Manual

Audison LRX 6 SR Owner's Manual

Hide thumbs Also See for LRX 6 SR:
Table of Contents

Advertisement

Quick Links

Download this manual See also: User Manual
Audison measurement standards
(Power measures taken according to audison standard, 1998 edition)
- 12VDC and 13.8VDC;
- 1 kHz or crossover cut-off frequency;
- 0.3% THD @ nominal power; 1% THD @ continuous power;
- Tolerance: +10%; -5%;
- Continous power given by RMS Voltage measured on resistive load;
- The nominal power of the amplifier is measured upon a battery voltage of 12 Volts with
a 4 Ohm load and with all channels in function.
is a division of
62018 Potenza Picena (MC) Italy
Tel. 0733.870870 • Fax 0733.870880 • http://www.audison.com • e-mail: com@audison.com
OWNER'S MANUAL
CAR POWER AMPLIFIER

Advertisement

Table of Contents
loading

Related Manuals for Audison LRX 6 SR

Summary of Contents for Audison LRX 6 SR

  • Page 1 - The nominal power of the amplifier is measured upon a battery voltage of 12 Volts with a 4 Ohm load and with all channels in function. OWNER’S MANUAL CAR POWER AMPLIFIER is a division of 62018 Potenza Picena (MC) Italy Tel. 0733.870870 • Fax 0733.870880 • http://www.audison.com • e-mail: com@audison.com...
  • Page 2 INTRODUCTION audison cable PRODUCTS FOR ELECTRIC CONNECTIONS Audison thanks you for preferring this product and compliments you on your choice since it was designed in order to insure outstanding musical and instrumental performances. Before use instructions, please carefully read the safety norms you have to respect in order to avoid unpleasant inconveniences and to enjoy this product at best.

  • Page 3: Table Of Contents

    ........

  • Page 4: Description

    Once the causes which implied protection circuits intervention have been checked and solved, the amplifier is reset by switching it off and on again. that audison logo is upside down. The amplifier is also provided with another general protection which is insured by an internal strip fuse, very easy to reach.

  • Page 5: In-Out Panel

    CONTROLS PANEL DIAGRAM AND SUBSONIC FILTER SWITCH outputs according to polarity. Terminal blocks accept cables up to 9 A.W.G. max (see “audison cable products for electric connections” as far as their size is concerned). We recommend the use of audison cable products.

  • Page 6: Power Supply Panel

    3 A.W.G. max. In order to get the best current transfer, please use power supply cables with as big a section as possible. audison cable catalogue offers you a complete range of such products which can satisfy whatever demands; you can also find Maincrimp terminals in it. We strongly recommend their use because they contain the cable non protected end and allow the terminal block to fasten all its useful section.

  • Page 7: Fuse Replacement

    ACCESSORIES POWER SUPPLY PANEL FUSE REPLACEMENT CLK2 – LRx Cooling Kit This cooling system is specially designed to provide LRx amplifiers with the right working temperature. CLK2 should be used when LRx amplifiers work in extremely hard conditions (very low loads) or in installations where space is too narrow and heat sink cooling is not enough.

  • Page 8: Controls Panel

    CONTROLS PANEL ACCESSORIES FUNCTIONS AND CONTROLS VCR01K, VCRAK and VCRDK LRx 6.SR can accept one of the optional kits that allow the subwoofer volume remote control. VCR01K and VCRAK are analogue and special for sub; VCRDK is digital and can be used for master volume control or for level control of any ways in a multichannel system.
  • Page 9 Nominal output power (RMS) 24dB/Oct. LO-PASS filter cut-off frequency If LED stays on, please contact Audison MAX SIZE (L x H x D): ..176 x 56 x 445 mm NP @ 12VDC; THD 0.3%: ....55W x 5 authorised after sale centres.

  • Page 10: Setting Panel

    SETTING PANEL SETTING PANEL FUNCTIONS SUBSONIC FILTER CUT-OFF FREQUENCY MODIFICATION It permits to reach the resistors to set subsonic filter cut-off frequency, the switch which activates Subsonic filter is pre-adjusted at 20 Hz. In order to modify this value, please act according to what subsonic filter (SUBSONIC) and to insert VCA modules for the subwoofer volume remote control.

Table of Contents