Monogram ZJ7000 Installation Instructions Manual page 11

STEP 4
SECURE CUSTOM PANEL TO
METAL MOUNTING PANEL
• Lay the custom panel, appearance side down, on a
clean surface.
• Remove all tape and packing material from the metal
panel.
• Place the flat side of the metal panel onto the back
side of the custom panel, with the mounting flanges
facing up.
• Align the lamp hole in the panel with the mounting
panel.
• Confirm squareness and correct position of the metal
panel to the custom panel.
STEP 5
FOR PANELS LESS THAN
3/4" THICK
• Separate the custom panel and metal panel.
• Apply a few horizontal beads of adhesive to the metal
panel. Avoid adhesive within 1" of lamp hole area and
outer edges.
FOR 3/4" (OR GREATER)
STEP 5A
THICK PANELS
• Separate the custom panel and metal panel.
• Use the metal panel as a template. Position the metal
panel over the back side of the custom panel and drill
pilot holes. Drill pilot holes sized to match screws being
used (screws not provided).
NOTE: Select screw length carefully to avoid penetration
of the finished side.
STEP 6
INSTALL LAMP JEWEL
• Turn the assembly appearance side up.
• Use plastic to wood adhesive to secure the lamp jewel
to the front of the wood panel. On the side with the
bulge, (see illustration) apply a small bead of adhesive
around the outside edge. Place the jewel into the
drilled hole.
This Side
Appearance
Against
Side
Wood
Installation
STEP 7
• A custom handle (not supplied) may be installed.
• Drill pilot holes through the front of the custom panel
and through the metal panel to match the chosen
handle.
NOTE: The handle screws should be installed through
the metal panel, the custom panel and into the custom
or original handle.
STEP 8
• Determine which holes in the metal panel line up with
the holes in the exposed drawer front and marked the
screw hole locations onto the custom panel.
• Drill 1/8" deep holes into the custom panel for
clearance to the #6 screws. The #6 screws will extend
into the custom panel slightly.
• Using the #6 screws supplied in the bag, install the
custom panel assembly to the exposed drawer front
with seven screws.
• The original #8 screws are not needed.
Insert
NOTE: Product improvement is a continuing endeavor at
Jewel
General Electric. Therefore, materials, appearance and
specifications are subject to change without notice.
11
REINSTALL ORIGINAL HANDLE
OR OPTIONAL CUSTOM HANDLE
INSTALL ASSEMBLED PANEL
TO THE DRAWER
Custom Handle
or Original Handle