LG LW6324 Series Owner's Manual page 15

ARP Ping
> Enable ARP Ping to configure IP address: Check to enable
ARP ping.
• Save: Click this button to confirm the settings.
RTP stream
RTP (Real-time Transport Protocol) is an internet protocol that allows
programs to manage the real-time transmission of multimedia data,
via unicast or multicast.
Master / Slave
> RTP unicast: When enabled the transmission of the data to
the specified equipment happens on a network specifying a
single address.
Operation and settings
> RTP multicast: When enabled it reduces the transmission
load on the camera by making the computer of the same
segment network receive the same transmission data. When
multicast option is checked then select Video Port number,
Audio Port number and Data port number.
- Video RTP port: Specify the video transmission port
number used for the multicast streaming. It is initially set
to 8 888 and you can edit this between 1 025 and 65 534.
- Audio RTP port: Specify the audio port number used for
the multicast streaming. It is initially set to 7 778 and you
can edit this between 1 025 and 65 534.
- Data RTP port: Specify the VA data port number used for
the multicast streaming. It is initially set to 6 666 and you
can edit this between 1 025 and 65 534.
- IPv4 address: Set the IP address for RTP multicast.
Note:
Each stream using multicast needs its own pair of multicast
IP address and port numbers to avoid address conflict.
TTL
> TTL: This option indicates the Time-To-Live of multicast
packets. The default setting is 7, and the allowed TTL range is
from 1 to 255.
• Save: Click this button to confirm the settings.
15