Hunter H31 Operator's Manual page 98

Note: If windlass becomes inoperable electrically, a
manual winch handle is supplied.
For more information about your windlass, refer to your
owner's manual.
Figure 7.5
7.3.12 Instruments
The breaker marked "Instruments", on the 12 Volt DC
Panel supplies power to the instruments on your boat.
For more information about the controls of your instru-
ments consult product manual in your owner's packet.
7.3.13 GPS
The breaker marked "GPS", on the 12 Volt DC Panel
supplies power to the GPS on your boat. For more infor-
mation about the controls of your instruments consult
product manual in your owner's packet.
7.3.14 TV/DVD
The reset marked "TV/DVD", on the 12 Volt DC Panel
supplies power to the TV/DVD on your boat. For more
information about the controls of your instruments con-
sult product manual in your owner's packet.
7.3.15 Head
The reset marked "Head", on the 12 Volt DC Panel sup-
plies power to the Head on your boat. For more informa-
tion about the controls of your instruments consult prod-
uct manual in your owner's packet.
7.3.16 CO Monitors
For your protection, we have installed CO monitors
aboard your boat. Be sure and check your Owner's
Packet for more info concerning your CO detectors. You
Hunter 31 • DC Electric
can also review the dangers of CO in the Boating Safety
Chapter of this manual.
Do not spray waxes or cleaning agents on the monitor.
7.3.17 Fire Extinguishing Systems (Option)
In the engine room, there is a fire extinguishing bottle
installed. This system is DC powered with a relay, or
"module", and the alarm at the helm station.
When a fire is detected on your boat, the alarm will sound
and set off the Halon bottle. This relay will shut down
the engine, and blower. To reset the system, activate
the override switch on the monitor at the helm. See Fig.
7.6.
7.3.18 Maintenance
The maintenance of your DC system is ensuring that all
connections are clean, tight, and covered with a corrosion
inhibitor compound.
7.8
Fire Alarm
High Water Alarm
Figure 7.6