Hunter H31 Operator's Manual page 95

The power switch turns the monitor on, then
select the tank you want to monitor. The gauge
will show the amount remaining in the tank(s).
The water and waste tanks are monitored from the tank
selection panel.The switch in #1 position monitors the
water tank. The waste tank is also monitored from this
location by switching to #2 position and center position is
"OFF" Fig. 7.3.
7.3 System Components and Operation
The largest part of your controls are on the 12 Volt DC
Panel, we will run down the systems and components as
they are listed on the Panel. From there, we will look at
the helm controls.
7.3.1 DC Main
In order to energize the DC system aboard your boat, you
must turn the breaker marked "DC Main", on the battery
switch panel, to the "ON" position. This supplies power to
the remaining breakers and systems on the DC Panel.
7.3.1.1 To operate the 12 Volt DC System:
1. Switch the main battery switch under chart table to
ON.
2. Switch the DC main circuit breaker at battery switch
panel to ON.
3. Switch on relevant breakers at the MDP.
Note: Always switch circuit breakers off when you leave your
boat unattended.
7.3.2 Lighting Systems
There are basically three different lighting systems
aboard your boat. These are the interior (Cabin) and
exterior lighting, and navigational lighting.
The navigational lighting, closely follows Coast Guard
regulations. They are as follows:
• Nav Lights
• Steaming Light
• Mast Light
• Deck Light
The red and green lights on the bow rail and the white
facing light on the transom are known as "Nav Lights".
Hunter 31 • DC Electric
These lights should always be on when motoring.
The "steaming" light is the forward facing light mounted at
the top of mast. This should be on when underway with
sail power only.
The anchor light is a 360 ° light mounted at the top
of the mast and should only be on when anchored.
Lighting circuits and locations are outlined in the end of
this chapter.
LPG bottle must always be firmly secured within
Flex-hose at stove must always run fair and be free
Vapor drain must always be clear and clean of ob-
structions continuously within and at each end.
7.3.3 LPG Stove
The breaker marked "LP Gas", supplies power to the
remote switch for your 2 burner gas stove. Refer to page
5.14 for the arrangement layout of this system.
7.3.3.1 Basic Stove Operation
1. On standard battery charger model, turn on house
battery selector switch (under chart table).
2. Turn on Main DC breaker at Battery Switch Panel.
3. Open valve to LPG bottle.
4. Turn on LP gas solenoid, switch located on end of
Galley.
Note: Consult product manual for operating the stove
and other information on the unit.
7.3.4 Refrigerators
The reset marked "refrigerator", on the 12 Volt DC
Panel supplies power to the refrigerator aboard
your boat.
out on page 4.16 for the location of the refrigerator.
7.5
their enclosure/locker.
of kinks and chafing.
Refer to Interior arrangement lay-