Sfp Information - Lancom GS-2310P User Manual

LANCOM GS-2310P/GS-2326(P) User Manual
3 Configuration
If desired it is possible to minimize the latency for specific frames, by mapping the frames to a specific queue (done with
QOS), and then mark the queue as an urgent queue. When an urgent queue gets data to be transmitted, the circuits will
be powered up at once and the latency will be reduced to the wakeup time.
Web Interface
To configure EEE in the web interface:
1. Click Configuration, Port, then EEE
2. To evoke which port wants to enable the EEE function.
3. EEE Urgent Queues level and the range from 1 to 8. the queue will postpone the transmission until 3000 bytes are
ready to be transmitted.
4. Click Apply.
Figure: EEE Configuration
Parameter description:
Port:
The switch port number of the logical EEE port.
EEE Enabled:
Controls if EEE is enabled for this switch port.
EEE Urgent Queues:
Queues set will activate transmission of frames as soon as any data is available. Otherwise the queue will postpone the
transmission until 3000 bytes are ready to be transmitted.
Buttons:
Apply – Click to save changes.
Reset – Click to undo any changes made locally and revert to previously saved values.

3.1.7 SFP Information

The section describes the SFP module information which you will see when you connect an SFP module to the switch.
The information includes: Connector type, Fiber type, wavelength, baud rate and Vendor OUI etc.
Web Interface
To display the SFP information in the web interface:
1. Click Configuration, Port, then SFP Information
Figure 3-1.6: The SFP Information Overview (GS-2310P)
19