Table of Contents
Advertisement
Kinesia HomeView User's Guide – 01/03/2013
Transferring a Study Definition to the Patient Station
1. Turn on the patient station by pressing down on the power button on top of the Tablet PC.
2. Click the Administration Options Button in the lower right corner of the screen (Figure 5).
3. Enter the administrative login password "glnthv" and click 'Proceed'.
4. Once the 'Administration Options' screen appears, click the 'Select Patient' tab followed by
the 'Refresh List' button. You will be prompted by the Tablet PC to enter your login
information to view a list of patients with studies that are pending upload.
5. To gain access to this list, enter the username and password you use to gain access to the
Kinesia HomeView web application into the fields on the Tablet PC and click 'Login'.
6. A list of patients with studies pending upload appears. Select the patient of interest.
7. Press 'Select.
• If data transfer is successful, 'Study Transfer Successful' will appear in red at the bottom
of the screen.
• If this message does not appear, repeat steps 4-7. If the transfer continues to fail, please
contact Great Lakes NeuroTechnologies customer support.
8. Press 'Exit'. The time and date of the patient's first test will be shown in red on the top of the
home screen.
9. Turn off the Tablet PC by pressing down on the power button. The system is now ready to
be sent home with the patient.
NOTE: Once a new study definition is transferred to the patient station, all patient data stored on
the Tablet PC from a previous study will be deleted.
Clinician-Guided Demo Mode – Administration Options Button
Demo mode can be used to guide patients through their study in the clinic before they are sent
home with Kinesia HomeView. Demo mode allows patients to practice the prescribed tests without
saving any data. To use demo mode, the new study definition must first be transferred to the
Tablet PC. To access demo mode:
• Click the Administration Options Button in the lower right side of the main screen and enter
glnthv.
• Click the 'Display Options' tab then select 'Set Demo Mode.'
• Click Close.
Click 'my Tests' for the patient to practice the prescribed tests. In order to exit demo mode, turn off
the Tablet PC by holding down the power button. The newly created study definition that was
uploaded to the patient station will remain on the Tablet PC for home use after the demo mode has
been exited.
NOTE: Turning off the Tablet PC during demo mode will cause the patient application to return to
the default mode upon startup.
25
Advertisement
Table of Contents
