Chapter 4: Patient Station Setup; Patient Station Assembly; Patient Station Display Options - Kinesia HomeView User Manual

Kinesia HomeView User's Guide – 01/03/2013

Chapter 4: Patient Station Setup

Patient Station Assembly

The Kinesia HomeView system will be sent home with patients in an easily accessible carrying
case. The patient should adhere to the following instructions for home assembly and use:
1. First remove the Tablet PC and place it in an upright position on an easily accessible table
or desk.
2. Using the color-coded system from Table 1, plug the AC power cable into the top-right
corner of the Tablet PC by matching up the green markers.
• Plug the other end of the AC power cable into a nearby wall electrical outlet.
3. Remove the Charging Pad from the carrying case and place it next to the Tablet PC. Plug
the AC power cable into the bottom-left corner of the Charging Pad.
• Plug the other end of the Charging Pad power cable into a nearby wall electrical outlet.
4. Place the Finger Sensor face down in the center of the Charging Pad.
5. Press the power button on the top of the Tablet PC indicated by a yellow marker.
6. The patient station will be ready for use once the home screen appears (Figure 3).
7. The current time and next test time are on the top right corner of the screen.

Patient Station Display Options

The Kinesia HomeView Tablet PC can display any combination of 'my Symptoms,' 'my Meds,' or
'my Tests' you would prefer. To change which buttons are visible:
1. Click the Administration Options button on the Tablet PC.
2. Enter glnthv.
3. Click Display Options.
4. Select or deselect the 'My Symp,' 'My Med,' or 'My Test' buttons appropriately.
19