Auxiliary Hydraulics; Standard Flow Auxiliary Hydraulics; High Flow Auxiliary Hydraulics - Gehl 5625SX Operator's Manual

NOTE: With the Keyswitch OFF, and if the
Solenoid Valve is working properly, the Arm
should remain in the raised position when the Lift
Control is moved forward. If the Valve does NOT
hold the Arm and the Arm begins to lower, do NOT
leave the Operator's Compartment. Instead, have
another person place the Lock into the "storage"
position for you. Then, contact your Gehl dealer
to determine the reason why the Lift Arm lowers
while the Keyswitch is in the "off" position.
5. To store the Lock, raise it up until it contacts the
Lift Arm and install the Lock Pin through the hole
in the Lock Anchor Pin under the Lift Arm.
AUXILIARY HYDRAULICS
Standard Flow Auxiliary Hydraulics
(Fig. 14)
Loaders are shipped from the factory with standard
flow Auxiliary Front Hydraulic connections. A pair of
Quick-disconnect Fittings, located at the left, inside
corner of the Lift Arm, can be used for operating
Attachments (Grapple, Backhoe, etc.).
T-Bar Controlled Loaders: A Footpedal is used to
control the direction of oil flow. A stop is provided to
lock the footpedal for continuous operation.
Hand/Foot Controlled Loaders: the right T-Bar is
twisted to control the direction of oil flow. A stop is
provided to lock the T-Bar for continuous operation.
High Flow Auxiliary Hydraulics
(Fig. 15)
In addition to standard flow Auxiliary Front Hydraulic
connections, model 5625DX Loaders are shipped from
the factory with High Flow Auxiliary Hydraulics. An
additional pair of Quick-disconnect Fittings, located at
right and left front corners of the Lift Arm, can be used
for operating high hydraulic oil flow Attachments
(Cold Planer, Snowblower, etc.).
A two-position, Toggle Switch is used to control the
operation of the High Flow Hydraulics. The two
positions on the Toggle Switch are:
OFF - which disables output to the Quick-disconnect
Fittings.
ON - which pressurizes the Top Male Port.
28
Fig. 13: Lift Arm Lowered & Lock "Stored"
1.
Lift Cylinder Mechanical Lock in "Storage" Position
2.
Lock Pin
3.
Left Side Lift Cylinder
Fig. 14: Standard Flow Auxiliary Hydraulics
1.
Standard Flow Quick-disconnects
Fig. 15: High Flow Auxiliary Hydraulics
1.
High Flow Auxiliary Hydraulics Control Switch
2.
High Flow Quick-disconnects
3.
Case Drain Line