Section 1. General Information; Introduction; Consumer Information And Safety; Spa/Hot Tub Safety Rules - Jandy Legacy LRZM Installation And Operation Manual

Table of Contents

Advertisement

Legacy

Section 1. General Information

1.1

Introduction

This manual provides installation and operation
instructions for the Legacy Model LRZ millivolt pool
and spa heater. Read these installation and opera-
tion instructions completely before proceeding with
the installation. Consult Zodiac Pool Systems, Inc., or
local factory representative, with any questions regard-
ing this equipment.
Certain sections of this manual are specifi c to
either United States or Canadian installations, and are
labeled as such.
The Legacy model LRZ millivolt heater is a self
contained standing pilot unit and requires no external
power.
The Legacy heater is specifi cally designed for
heating fresh water swimming pools and spas, and
with proper installation and care, they will provide
years of reliable service. Do not use the heater to
maintain pool or spa water temperature below 70°F.
Do not use it as a heating boiler or general service
water heater or to heat salt water. Consult your dealer
for the appropriate Jandy products for these applica-
tions.
NOTE "Fresh water swimming pools and spas"
include systems that utilize saltwater chlorine
generator units, such as the Jandy AquaPure
Electronic Chlorine Generator. Please ensure
that the salt content of the pool/spa does not
exceed 4000 ppm and water fl ow rate is within
30-125 gpm (110-475 lpm).
1.2

Consumer Information and Safety

The Legacy heater is designed and manufactured
to provide many years of safe and reliable service
when installed, operated and maintained according
to the information in this manual and the installation
codes referred to in later sections. Throughout the
manual safety warnings and cautions are identifi ed by
the "
" symbol. Be sure to read and comply with all
of the warnings and cautions.
1.2.1

Spa/Hot Tub Safety Rules

WARNING
The following "Safety Rules for Hot Tubs," recom-
mended by the U.S. Consumer Product Safety
Commission, should be observed when using the
spa.
AVERTISSEMENT
Les Règlements suivants pour Cuves Thermales,
tel que recommandés par la Commission U.S. de
Sécurité des Produits pour les Consommateurs,
devraient être respectés lors de l'utilisation du spa.
Model LRZM Pool/Spa Heater Installation and Operation Manual
The U.S. Consumer Product Safety Commission
warns that elevated water temperature can be haz-
ardous. Consult heater operation and installation
instructions for water temperature guidelines before
setting temperature.
La U.S. Consumer Product Safety Commission
indique que des températures de l'eau élevées peu-
vent être dangereuses. Voir la notice d'installation
et de fonctionnement pour le réglage de la tempéra-
ture.
1.
Spa or hot tub water temperature should never
exceed 104°F (40°C). One hundred degrees
Fahrenheit (100°F [38°C]) is considered safe for
a healthy adult. Special caution is recommended
for young children.
2.
The drinking of alcoholic beverages before or
during spa or hot tub use can cause drowsiness
which could lead to unconsciousness, and subse-
quently result in drowning.
3.
Pregnant women take note! Soaking in water
above 102°F (38.5°C) can cause fetal damage
during the fi rst three months of pregnancy (which
could result in the birth of a brain-damaged or
®
deformed child). If pregnant women are going
to use a spa or hot tub, they should make sure
the water temperature is below 100°F (38°C)
maximum.
4.
The water temperature should always be checked
with an accurate thermometer before entering a
spa or hot tub. Temperature controls may vary by
as much as 1F° (1C°).
5.
Persons with a medical history of heart disease,
diabetes, circulatory or blood pressure problems
should consult their physician before using a hot
tub or spa.
6.
Persons taking any medication which induces
drowsiness (e.g., tranquilizers, antihistamines, or
anticoagulants) should not use spas or hot tubs.
7.
Prolonged immersion in hot water can induce
hyperthermia.
Hyperthermia occurs when the internal body
temperature reaches a level several degrees above the
normal body temperature of 98.6°F (37°C). Symptoms
include dizziness, fainting, drowsiness, lethargy, and
an increase in the internal body temperature. The
effects of hyperthermia include:
Lack of awareness of impending hazard
WARNING
AVERTISSEMENT
Page 5

Advertisement

Table of Contents
loading

Table of Contents