Wall Installation - AT&T 5845 User Manual

5840_CIB_2ATT 2003.3.5
figure a
figure b
figure c
figure d
figure e
6:11 PM Page 5

Wall Installation

1 Connect the power cord and
telephone line cord to the underside
of the corded base, as shown
(figure a).
2 Position the mounting bracket as
shown (figure b).
3 Feed the telephone line cord thro u g h
the hole in the center of the mounting
bracket (figure b), align the bracket
with the base, and slide it into the
hole on the base as shown (figure c).
4 Lock the mounting bracket in place
(figure d).
5 Plug the telephone line cord into a
modular wall jack, and mount the
base on the wall (figure e).
a) Align holes on base with mounting
b) Place power cord as shown.
c) Pull base down on mounting studs
6 Plug the power cord into an
electrical outlet not controlled by a
wall switch (figure e).
7 Follow Steps 3–5 in "Table/Desktop
Installation."
studs on wall jack.
until it locks into place.
Use only the power cord supplied
with this pro d u c t . If you need a
re p l a c e m e n t , call 1 800 222–3111.
6