H8QG7/i-LN4F Serverboard User's Manual
Universal Serial Bus Ports
Two Universal Serial Bus ports (USB
2.0) are located beside the Keyboard
and Mouse PS2 ports (USB0/1).
One additional Type A port (USB6) is
included on the motherboard. See the
table on the right for pin defi nitions.
USB Headers
Four USB 2.0 headers (USB2/3
and USB4/5) are also included on
the motherboard. These may be
connected to provide front side access.
A USB cable (not included) is needed
for the connection. See the table on the
right for pin defi nitions.
SGPIO
The T-SGPIO1/ T-SGPIO2 (Serial
G e n e r a l P u r p o s e I n p u t / O u t p u t )
headers provide a bus between the
SATA controller and the backpane to
provide SATA enclosure management
functions. Connect the appropriate
cable from the backplane to the
T-SGPIO1 header to utilize SATA
management functions on your system.
Standby Power Connector
The Standby Power connection
header is located at JSTBY1 on the
motherboard. See the table on the right
for pin defi nitions. (You must also have
a cable to use this feature.)
Universal Serial Bus Ports
Pin Defi nitions (USB 0/1, USB6)
USB0/1
Pin# Defi nition
1
+5V
2
PO-
3
PO+
4
Ground
Universal Serial Bus Headers
Pin Defi nitions
(USB2/3, USB4/5)
JUSB2, JUSB3
Pin# Defi nition
1
+5V
3
PO-
5
PO+
7
Ground
9
Key
Note: NC indicates no connection.
SGPIO Header Pin Defi nitions
(T-SGPIO1/T-SGPIO2)
Pin# Defi nition
1
NC
3
Ground
5
Load
7
CLK
Standby Power
Pin Defi nitions
Pin#
1
2
3
2-16
USB6
Pin# Defi nition
1
+5V
2
PO-
3
PO+
4
Ground
Pin# Defi nition
2
+5V
4
PO-
6
PO+
8
Ground
10
NC
Pin# Defi nition
2
Data
4
Data
6
Ground
8
NC
(JSTBY1)
Defi nition
+5V Standby
Ground
Wake-up