Front Control Panel; Power Indicator - Mitsubishi WD-65000 Owner's Manual

Part II : Installation

Front Control Panel

Many remote control buttons are duplicated on the front control panel. These buttons are shaded in figure 1.
Please see Remote Control Functions, pages 48 - 55, for an explanation of their usage.
POWER
STATUS POWER
1 2
Figure 1. Front Control Panel
Status indicator
1
This indicator informs of the status of the projection TV. See below.

Power indicator

2
This indicator informs of the power condition of the projection TV. See below.
Under normal operation
STATUS POWER CONDITION
Off
Off Off
Initialization when first plugging inyour TV, or lamp cooling
Off
Steady (10 - 45 seconds)
red
Lamp start-up (for 30 seconds)
Off
Steady
yellow
The POWER is ON
Off
Steady
green
Stand-by (When the TV is set to turn on at a specific time.)
Off
Blinking
green
Abnormal operation notice
STATUS POWER CONDITION
Unusual temperature
Off • The air-filter is dirty.
Blinking
yellow/red
• The room temperature is too high.
Lamp usage warning. (Usage total about 4, 000 hours.)
Any state
Steady
yellow
Lamp failure
Off
Blinking
red/green
Lamp cover or filter cover is open.
Blinking
Off
yellow/green
Service required.
Off
Blinking
red
A/V Reset
3
Press this button to reset the A/V memory on all inputs to the factory default settings. Please
see A/V Memory Reset , page 41, for instructions.
PC-2
4
This input can be used for the convenient connection of a compatible computer. Please see
Appendix B , page 59, for signal compatibility.
Input 5 (S-VIDEO / VIDEO)
5
This input can be used for convenient connection of a camcorder or other video device. Please
note that if you connect to the S-VIDEO terminal, the VIDEO terminal is deactivated.
L - AUDIO - R
6
Audio input to the AUDIO IN terminal on the front panel is possible for a component connected
to either PC-2 or Input 5.
12
VOLUME CHANNEL ENTER MENU
ADJUST ADJUST ENTER MENU
PC-2
4
A/V RESET INPUT
CANCEL
3
Figure 2. Located under Control Panel Overhang
NOTES
TV will turn on in 10 - 30seconds.
POSSIBLE SOLUTIONS
• Clean the filter. (See page 64).
• Relocate the projector to a cooler place.
• Replace the lamp. (See page 61.)
• Wait 1 minute, then press the POWER button.
• If the above operation is not effective, replace
the lamp.
• Close the cover correctly.
• Contact your dealer.
INPUT - 5
S-VIDEO VIDEO L–AUDIO–R
5
6