Mitsubishi WD-52525 Owner's Manual page 101

Troubleshooting, continued
Problem
52. ChannelView program recording failed.
53. TV is not responding, after pulling out a Memory
card during playback.
54. TV can't play or stop a media card.
55. Can't see a thumbnail picture in the JPEG
menu, or can't see a track/song name in the
Playlist menu.
Using The System Reset Button
If the TV doesn't respond to either the remote control or the front panel controls or will not power off, press the
SYSTEM RESET button on the front panel with a pointed item such as the point of a ball point pen or end tip of a
paperclip.
The TV will turn off and the green led will flash quickly for about one minute. When the green led stops flashing,
you may turn on the TV again. The changes you made while the TV was most recently on, before you used the
SYSTEM RESET button may lost, however, the changes you made previously are not lost. Only those changes
since the last power On may be lost when the system reset button is pressed. All other settings are retained.
Possible Solution
• Connection and compatibility issues with IEEE 1394 (FireWire®)
digital devices. This may include too many Firewire devices in use at
one time, or the recording device not understanding the record
command.
• Television lost power long enough to lose current clock time.
• Analog VCR power was left Off.
• Press STOP or wait until playback is complete before removing
media card.
• NetCommand was not set up. Without NetCommand enabled, you
can only use ENTER to play and CANCEL on the TV remote to control
the media cards.
• File does not meet file standards for playback.
101