Table of Contents
Advertisement
ANSWERING SYSTEM
PROBLEM
If the system does not
answer after the correct
number of rings:
PROBLEM
If
appears in the
message window:
PROBLEM
If the system does not
respond to commands
from a remote touch
tone phone:
5 8
SOLUTION
• Make sure that the answering system
is on.
• If Toll Saver is on,the number of rings
changes to two when you have new
messages waiting.
• In some cases,the system may be
affected by the ringing system used by
the local telephone company.
• If the memory is full or the system is off,
the system answers after 10 rings.
SOLUTION
You need to reset the clock. See "Set
the Clock" in the ANSWERING SYSTEM
OPERATION section of this manual.
SOLUTION
• Make sure you are calling from a touch
tone phone. When you dial a number,
you should hear tones. If you hear clicks
instead,the phone is not a touch tone
telephone.
• Make sure you enter your Remote Access
Code correctly.
• There may be noise or interference on
the phone line you are using. Press
keys firmly.
Advertisement
Table of Contents
