Brake Pad Wear Limit Indicators - Toyota TUNDRA 2004 Owner's Manual

Either of the following conditions may
occur, but do not indicate a malfunc-
tion:
The light may stay on for about 60
D
seconds after the ignition key is turned
to the "ON" position. It is normal if it
turns off after a while.
Depressing the brake pedal repeatedly
D
may turn on the light. It is normal if it
turns off after about a few seconds.
'04 TUNDRA_U (L/O 0309)
BRAKE ASSIST SYSTEM (with the ve-
hicle stability control system)
When you slam the brakes on, the
brake assist system judges as an emer-
gency stop and provides more powerful
braking for a driver who cannot hold
down the brake pedal firmly.
When you slam the brakes on, more pow-
erful braking will be applied. At this time,
you may hear a sound in the engine
compartment and feel the vibrations of the
brake pedal. This does not indicate a mal-
function.
The brake assist system becomes opera-
tive after the vehicle has accelerated to
a speed in excess of approximately 10
km/h (6 mph). It stops operating when the
vehicle decelerates to a speed below
approximately 5 km/h (3 mph).
For an explanation of this system's warn-
ing light, see "Service reminder indicators
and warning buzzers" in Section 1−6.
Brake pad wear limit
indicators
The brake pad wear limit indicators on
your disc brakes give a warning noise
when the brake pads are worn to where
replacement is required.
If you hear a squealing or scraping noise
while driving, have the brake
checked and replaced by your Toyota
dealer as soon as possible. Expensive ro-
tor damage can result if the pads are not
replaced when necessary.
2004 TUNDRA from Sep. '03 Prod. (OM34426U)
pads
331