Mitsubishi Electric LT-40133 Owner's Manual page 78

78
Appendices
Appendix E: Troubleshooting, continued
Reset Name When to Use
Side Panel Lock
To re-enable the side-
Release
panel controls after
activation of the Side
Panel Lock
System Reset If the TV does not turn on
or off, does not respond
to the remote control or
side panel buttons, or
has audio but no video.
TV Reset
To reset all consumer-
IMPORTANT:
accessible settings
Use this reset and all memories to the
only if all other original factory defaults.
resets have been
CAUTION: All owner-
unsuccessful.
performed setups and
adjustments will be
erased.
Service and Support
Service
If you are unable to correct a problem with your TV,
consult Mitsubishi Consumer Relations at:
(800) 332-2119.
• DO NOT adjust any controls other than those
described in this Owner's Guide.
• DO NOT remove the protective back cover of your
TV.
How to Use
When Energy Mode is set to Fast
•
Power On, press and hold the MENU
button on the side panel for over
eight seconds.
• When Energy Mode is set to Low
Power, press POWER on the side
panel to turn on the TV. Wait for TV
to turn on, then press and hold the
MENU button on the side panel for
over eight seconds.
Press the SYSTEM RESET button on the side
panel with a pointed object such as the
point of pencil or end tip of a paperclip.
While viewing the TV, press MENU to
1.
Main
display the TV menu.
Main
2. With the menu displayed,
press number keys 1 2 3 to display
Reset
the menu.
READ THE ON-SCREEN
3.
WARNING AND INSTRUCTIONS.
• If you do not wish to use this
reset, press EXIT or MENU to back
out.
• If you do wish to use the reset,
press ENTER to erase all memo-
ries and settings.
Support
• To order replacement (or additional) remote
controls or Owner's Guides, visit our website at
www.mitsuparts.com or call (800) 553-7278.
• For questions:
Resulting Action
Allows the side panel controls to
be unlocked if the remote control is
misplaced.
The TV will turn off and the blue LED
will flash quickly for about one minute.
When the blue LED stops flashing,
you may turn on the TV. The changes
you made most recently, before using
SYSTEM RESET, may be lost. Changes
you made previously, however, are
not lost.
The TV will start the initialization
process. The TV will then turn off
and the front blue LED will start
flashing. When the LED stops
flashing (approx. 1 min.), you
can turn the TV on again. The
Parental Lock Pass code will remain
unaffected, but all other memories
and settings outlined in this Owner's
Guide will need to be set again.
Call Consumer Relations at 800-332-2119.
E-mail: MDEAservice@mdea.com
Website: www.mitsubishi-tv.com