Stand Removal Instructions - Mitsubishi Electric LT-40133 Owner's Manual

Stand Removal Instructions

At least TWO PEOPLE are needed to safely remove the stand. One person must hold the TV, while the
other person removes the stand. Failure to follow these recommendations may result in personal injury,
as well as damage to the product.
Stand Removal Procedure:
1. Before starting to remove the stand, make sure to
disconnect AC power cord from AC power outlet.
2. Spread the protective sheet that was wrapped
around the TV on a flat, even surface (such as a
sturdy table). The protective sheet will help prevent
the display from being damaged.
IMPORTANT: To avoid damaging the screen,
make sure there are no foreign objects under or
on top of the protective sheet.
3. With two people firmly grasping the left and right
sides of the TV, gently place TV face down on the
protective sheet with the display stand hanging
over the edge of the table. See the illustration to
the right.
4. Use a magnetic philips screwdriver to remove the
four (4) stand screws from the recessed holes (see
illustration to right). Note: A regular screwdriver
can be used with a separate magnetic pickup tool.
5. While one person holds the TV with both hands, the
other person grasps the plastic portion of the stand
(see illustration to the right) and removes the stand
by pulling it away from the TV in the direction of the
large arrow shown in both illustrations.
6. The TV is now ready for wall mounting. See Wall
Mount Kit below.
Wall Mount Kit (purchased separately)
To order a Wall Mounting Kit, please contact Peerless
Industries, Inc. at (800) 473-3753 or visit www.peerless-
mounts.com.
• For TV Models LT-40133 and LT-40134, use wall
mounting kit Model ST635.
• For TV Models LT-46133, LT-46144, LT-52133, and
LT-52144, use wall mounting kit Model ST650.
Note: Complete instructions are included with the kit.
To order a Wall Mounting Kit from Mitsubishi Digital
Electronics America, Inc., please visit
www.mitsuparts.com or call (800) 553-7278.
CAUTION
CAUTION: Use with other than the authorized
accessories may cause the TV to become unstable,
which can cause damage to the product or possible
injury.
Before attaching the wall mount kit to the TV, be
sure to connect all necessary cables to jacks
on the back of the TV. After wall-mounting,
these jacks will not be accessible.
If you plan to connect a PC to the TV, before
wall-mounting be sure to connect an HDMI
cable and sound cable (if required) to the
proper inputs on the back of the TV. If your TV
is a model LT-40134, you can use the HDMI 4
jack on the side panel.
IMPORTANT