Table of Contents
Advertisement
Available languages
Available languages
ENGLISH
ENG
1
I
Switching on/Continuous activation: Push
sliding switch (1) forward. For continuous
activation, now tilt downwards until it
engages.
Switching off: Press the rear end of the slide
switch (1) and release.
7.2
Setting belt speed
The belt speed can be preset via the setting wheel
(2)and is infinitely variable.
Positions 1-6 correspond approximately to the
following belt speeds:
1 ......... 2.7 m/s
2 ......... 3.8 m/s
3 ......... 5.1 m/s
7.3
Sanding belt replacement
See illustration on page 3.
- Release the tensioner arm (5) and remove the
sanding belt (6).
- Place the new sanding belt on the rollers such
that its direction of circulation (arrows on the
inside of the sanding belt) matches the arrow (7)
on the gearbox.
- Release the tensioner arm (5).
- Ensure that the sanding belt is completely on the
rollers.
7.4
Sanding procedure
Place the machine on the material such that the
sanding belt is parallel to the surface of the work-
piece.
When working, please ensure that the machine is
operated at right angles to the pipe so that the belt
does not fall off the rollers.
Using the additional handle, the belt can be
pressed against the pipe and at same time placed
around it. The angle of contact and the cutting
output may be changed by the contact pressure.
Keep the machine in constant motion because
otherwise recesses could be produced in the
material.
8 Cleaning, Maintenance
Motor cleaning: blow compressed air through the
rear ventilation slots of the machine regularly,
8
0
4 ........6.3 m/s
5 ........7.6 m/s
6 ........8.5 m/s
frequently and thoroughly. Here, the machine must
be held firmly.
9 Troubleshooting
The electronic signal display (3) lights up
and the load speed decreases. The coil
temperature is too high! Run the machine in
idling until the electronics signal indicator switches
off.
The electronic signal display (3) flashes
and the machine does not start. The
restart protection is active. If the mains plug
is inserted with the machine switched on, or if the
current supply is restored following an interruption,
the machine does not start up. Switch the machine
off and on again.
10 Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
The dealer needs to know the exact model of your
power tool in order to select the correct accessory.
For a complete range of accessories, see
www.metabo.com or the main catalogue.
11 Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.
12 Environmental Protection
Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.
13 Technical Specifications
Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
Advertisement
Table of Contents
