Figure 7: Attaching The Bracket To A Wall Or Vertical Surface; Figure 8: Attaching The Bracket To A Pole - BCF Solutions DOG 2 PTZ User Manual

Figure 7: Attaching the Bracket to a Wall or Vertical Surface

To attach the mounting bracket to a pole, place and hold the bracket in the desired location. Take one of
the provided steel fastener straps from the kit and wrap it around the bracket base so that the steel band
lines up with the notched grooves on the edges of the bracket as shown in the figure below. Tighten the
steel fastener strap with a flat head screwdriver as shown.

Figure 8: Attaching the Bracket to a Pole

Once the bracket has been securely connected to a wall or pole, pull on it to make sure that it will hold
the weight of the pan tilt unit and camera. Next remove the bolts from the Pole Mount Bracket bag
provided in the kits along with the supplied Allen wrench. Place the pan tilt unit on top of the bracket
and align the pin on the shaft with the alignment hole in the bracket as seen in the figure below. Then
place a lock washer on each bolt and insert the bolts into the holes from underneath the bracket as shown.
Screw the bolts down with the Allen wrench until tight as seen below.
*It is recommended that this operation be done by two people or more. *
8