Mounting The High Performance Low Profile Ptz Units; Surface Mounting The High Performance Low Profile Ptz Unit; Figure 4: Surface Mount Accessories - BCF Solutions DOG 2 PTZ User Manual

Mounting the High Performance Low Profile PTZ Units

The two main mounting methods of surface mounting and wall/pole mounting are covered in the
following sections.

Surface Mounting the High Performance Low Profile PTZ Unit

Surface mounting the High Performance Low Profile PTZ unit to a flat surface such as a roof or pedestal
requires the attachment of a Pedestal Mount Adapter Plate using the bag of the included Pedestal Mount
screws as seen in the figure below. The camera Home or 0 Position indicated in the figure is the 0 degree
pan position and should be pointed at the center of the surveillance area. The camera will pan +/- 180
degrees about that point. The Alignment Hole indicated in the figure is for alignment of the pan tilt unit
shaft.

Figure 4: Surface Mount accessories

Position the adapter plate, with the non-countersunk-holes against the shaft (countersunk holes on other
side of the shaft) and align the pin on the shaft with the Alignment hole on the plate as seen in the figure
below. Insert the three 1/4-20 x 5/8 flathead machine screws and tighten the screws using a Phillips head
screwdriver, but do not tighten the screws completely until all three are inserted.
5