Table of Contents
Advertisement
Door Assembly Installation Instruction
Kit contains:
The Rinnai Luminaire Outdoor Gas Fire door assembly comes flat packed in 1 box and contains the
following:
Before Installation
Has the Rinnai Luminaire Outdoor Gas Fire already been installed? If yes, you will need to remove
the frame and burner assembly before fitting the doors.
Fit door swing arms
Remove left and right swing arms from the
assembly kit.
Fit into the smaller pre-drilled holes of the
Luminaire cabinet using the smaller 4 pcs M4 x 8
screws provided (2 screws per mount).
Install body/burner assembly
The body/burner assembly needs to be fitted before the doors as doors reduce entry access into the
enclosure.
New Installation
Retrofit
Fix doors to cabinet
Step 1 - Slot the C-shaped door bracket
over the louvre ensuring the holes line up
with those on the unit. Reset door on the
swing mount, this will help you level the
door.
Step 2 - Secure 2 pcs M5 x 10 screws into
the side frame, level as best you can and fix
in place with remaining 4 screws. DO NOT
tighten at this stage as you will need to
align both doors. See alignment page 19.
Step 3 - Repeat Steps 1 & 2 with the other
door.
Rinnai Australia
DOOR ASSEMBLY
Component
1
Left hand glass panel and surround
2
Right hand glass panel and surround
3
Swing arm kit
-
Screws M4 x 8 (for fitting swing arms into cabinet)
-
Screws M5 x 10 (for fitting swing arms to doors)
If you have purchased your doors with the Luminaire
Outdoor Gas Fire you need to install the body/burner
assembly. Simply unpack, slide into enclosure and fit granite
pieces into place.
If the doors are being retrofitted the burner assembly needs
to be fitted back into the cabinet. Simply reinstall by
reversing steps taken to remove it, refer page 19.
- 18 -
Rinnai Luminaire® Outdoor Gas Fire - Operation and Installation Manual
Quantity
1
1
1
4
2
Advertisement
Table of Contents
