Table of Contents
Advertisement
CUSTOMER INFORMATION - OPERATION
The Rinnai Luminaire Outdoor Gas Fire is easy to operate via the use of the control knob on the front
of the Fire.
All Rinnai appliances meet or exceed the safety Australian standards required for gas regulations.
Your Rinnai Luminaire Outdoor Gas Fire has the following safety devices:
• Burner lights with a low gas rate (lights to pilot).
• Flame failure device, if the gas is on and there is no flame the gas is automatically shut off.
Before starting the appliance
When starting the appliance for the first time ensure all packing and packaging materials has been
removed. This includes protective pvc coating to stainless steel and foam protection.
Before starting ensure that debris such as leaves or other objects are cleared from the unit, doors are
open, cover removed and the gas is turned on.
Operating the appliance
Step 1. Press the control knob
and S-L-O-W-L-Y turn
counterclockwise until
you hear a click. This
step is 'lighting to pilot'
and you are looking for
the pilot flame in the
pilot flame housing.
At this point the pilot
light should be
visible continue to
hold the knob down.
Step 2. Keep holding down for a further 5 seconds to active the flame and then release. Steps 1 &
2 may need repeated several times to ignition the Fire. If main burner has not ignited within
5 attempts see troubleshooting section refer to page 9.
Step 3. Once the appliance is on it is best to run on a high setting for a period of time in order to
establish a flame pattern and allow the unit to heat up, approximately 30 minutes. You can
adjust the flame by selecting between the high and low settings.
OFF
Pilot
Step 4. To turn off press the control knob and turn clockwise to the 'OFF' position. When shutting
down your Rinnai Luminaire Outdoor Gas Fire it is important you replace the cover once
the Unit has cooled down.
Step 5. If using ULPG gas cylinder ensure you turn 'OFF' at the isolator valve at the cylinder.
.
•
Outdoor Fires are not fully weatherproof and should NOT be directly exposed to
the rain. A stainless steel cover has been provided with the unit to protect the
CAUTION
burner and burner material when not in use.
•
Remember to remove the cover before starting this appliance. It is
recommended when positioning the appliance, that it is in a location that is
protected/covered to prevent full exposure to the rain.
.
•
REMOVE THE WEATHER COVER BEFORE LIGHTING.
•
DO NOT OPERATE APPLIANCE WITH THE COVER ON.
WARNING
Rinnai Australia
OFF position
Pilot
(turn slowly to this position
unit you hear a "click")
High
Setting
- 8 -
Rinnai Luminaire® Outdoor Gas Fire - Operation and Installation Manual
Low
Setting
Advertisement
Table of Contents
