eka KF 912 Use And Instruction Manual page 5

Hide thumbs

Table of Contents

_ Electric Ovens _ rev. 4__________________ KF 937 – KF 937 UD – KF 933 – KF 933 U – KF 933 AL – KF 933 AL U

Appliance model

Max. absorbed power

(kW)

Power supply voltage

(V~)

Class

Power cable

Power cable diameter

Power cable

diameter

Type of

Type of c c c c able

able

Type of

able

Connecting electric cable

Dimensions of appliance

(mm) LxDxH

Weight of appliance

(Kg)

The noise level of the appliance in operation is below 70 dB (A).

The "technical data" plate is positioned on the rear panel of the appliance.

4. 4. 4. 4. Instructions for the installer

Instructions for the installer

The following instructions are aimed at the qualified installer, to ensure that he carries out the

installation, adjustment and maintenance operations as correctly as possible and according to

current legal regulations. Any operation must be performed with electrical power cut to the

appliance.

Before using the appliance, carefully remove the special adhesive film protecting the parts in

stainless steel. Do not leave any glue residues on the surfaces. If necessary, remove them at once,

with an appropriate solvent.

Fitting the feet - The feet are inside the appliance and must be secured on the four threaded

Fitting the feet

holes on the base. If necessary, the height of the feet can be adjusted by screwing or unscrewing.

Positioning - Position the appliance perfectly horizontally on a table or similar support (the

Positioning

table or support must be at least 85 cm above the floor). Position it at a distance of not less than

10 cm from the side and rear walls, to enable natural ventilating air to circulate freely around it.

The appliance is ventilated through specific openings on the metal walls of the outer housing ,

and ensures efficiency and long-life. For this reason it is strictly forbidden to obstruct these

ventilation openings, even partially or for short periods. Failure to observe this specific prohibition

releases the manufacturer of the appliance fro

releases the manufacturer of the appliance from all responsibility and immediately voids any

guarantee rights for the said appliance,

guarantee rights for the said appliance, because its constructive conformity has been voluntarily

compromised. Furthermore, the appliance is not suitable for embedding and for grouped

positioning with other identical appliances.

Electrical connection - The appliance must be connected to the electrical mains according to

Electrical connection

current legal regulations. Before making the connection, make sure of the following:

the voltage and frequency values of the power supply system match the values on the

"technical data" plate affixed on the appliance;

the limiting valve and the system are able to support the appliance's load (see the

"technical data" plate);

the power supply system has an adequate earth connection according to current legal

the power supply system has an adequate earth connection according to cu

regulations;

a omnipolar switch with minimum between-contacts aperture of the overvoltage category

III (4000 V), sized to the load and conforming to current legal regulations, is fitted

between the appliance and the mains in the direct connection to the mains;

the omnipolar switch used for connection is easy to reach when the appliance is installed;

the yellow/green earth wire is not interrupted by the switch;

the power supply, when the appliance is operating, must not deviate from the rated

voltage value by ±10%;

_________________________________________________________________________________________ page 5 _

KF 912 - KF 912 IX – KF 965 – KF 965 M – KF 965 AL UD – KF 966 UD _

KF 937

KF 933 U

KF 933 U – – – – KF 933 AL

KF 933 U

KF 937 UD

3,7

220/230

(50 Hz)

220/230

(50 Hz)

3 x 1,5 mm

790x665x505

KF 933

KF 933 AL

KF 912 IX

KF 933 AL U U U U

KF 933 AL

6,4

380/400 2N

220/230 (50 Hz)

220/230

(50Hz)

I (contro la scossa elettrica)

4 x 2,5 mm m m m

4 x 2,5 m

3 x 1,5 mm

4 x 2,5 m

3 x 1,5 mm

H07RN- - - - F F F F

H07RN

Type Y

790x665x635

9 9 9 9 0 0 0 0 0x680x5

0x680x57 7 7 7 0 0 0 0

790x665x635

0x680x5

61/62/58/59

/62/58/59

Failure to observe this specific prohibition

m all responsibility and immediately voids any

KF 965

KF 912

KF 96

KF 965 AL

KF 965

KF 965 M M M M – – – – KF 966 UD

KF 965

3,4

(50 Hz)

380/400 2N

(50 Hz)

380/400 2N

4 x 2,5 mm

900x680x5

0x680x5

0x680x57 7 7 7 0 0 0 0 (KF 965 ..)

790x665x635 (KF 966 UD)

5 5 5 5 3 3 3 3

58/56/6 /6 /6 /60 0 0 0 /56

58/56

KF 965

5 AL UD

5 AL

KF 966 UD

6 6 6 6 ,4 ,4 ,4 ,4

(50Hz)

(KF 965 ..)

/56

rrent legal

Table of Contents

Show Quick Links

Hide quick links:

Table of Contents

This manual is also suitable for:

Kf 965 m Kf 937 Kf 937 ud Kf 965 Kf 933 Kf933 u ... Show all

eka KF 912 Use And Instruction Manual page 5

Hide quick links:

Related Manuals for eka KF 912

Related Products for eka KF 912

This manual is also suitable for:

Table of Contents